Will the surveyor have to measure to locate the new station

Reference no: EM13548162

Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23 will the surveyor have to measure to locate the new station?.

Reference no: EM13548162

Questions Cloud

Compute the value of pb in atm when h=10 m and density : A large closed tank is pressurized as shown. A jet of fluid issues from a small hole. Assume the flow is incompressible, irrotational, quasi-steady and the only body force acting is gravity.

Will there be any difference between the discharge velocitie : If a hose whose discharge end is left open on the ground is first connected to the lower valve and then to the higher valve, will there be any difference between the discharge rates of water for the 2 cases? Neglect frictional effects.

A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.

Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..

There will be 3 hurricane-free years within the next 5 years : A 10-year hurricane is subjected to occur at a given region. Determine the probability that:

What percentage of the total load is carried by the shaft : What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft?

Estimate its load carrying capacity assuming a safety factor : A 12 m-long and 800 mm-diameter drilled pier is constructed in a clayey soil with a1.5 m-diameter bell at the base. The top 7 m of the clay has an average Cu of 40 Kpa and the clay underneath has a Cu of 90 Kpa

For the problem compare two cases : A 250 mm- diameter and 16 m-long timber pile is driven into a sandy soil where ?= 18 kN/m3 and ?' = 34 degree. Estimate the maximum load allowed on the pile with a safety factor of 2.5

User Account

All Pages