Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1) Ohm's Law is considered one of the key foundation in electronics . Why?
(2) Why do we have to build and test circuits when we have simulation tools?
Discretization - How does the size of the differential charge elements influence your results Find E at the point (0, a/2, a), for this study. Devise a good way to represent your data to demonstrate the influence of discretization.
(a) Convert the expression for f(x, y, z) = fm(1, 3, 7) from minterm list from to maxterm list form. (b) Convert the expression for f(a, b, c, d) = fM(0, 1, 2, 3, 4, 6, 12) from maxterm list from to minterm list form.
determine the following by sloving laplace equations: a) the potential and electric field distribution in the dilectric slab. b) the potential and electric feild distrivution in the air space between the dilectric slab and the upper plate and c) t..
The resistance of the filament of the bulb, measured with a standard multimeter, is 16.7 ohms. When the bulb is connected into the circuit and is operating at the rated values given above determine a) the resistance of the filament b) the efficien..
A current element of length 1cm is located at (1m, 3m, 4m) in free space and carries a current of 20mA along ay. An infinitely long filamentary current of 12A along az passes through the coordinate origin (0,0).
A 50-Ohm line is terminated by a (60 +j60) Ohm load. An adjustable shorted shunt stub is placed 0.23 Lambda from the load. What is the smallest standing wave ration that can be achieved between the generator and the line by adjustment of the stub ..
A series of combination having R=2Mohm and C=0.01 UF is connected across a D.C. voltage source of 50V. Determined capacitor voltage and charging current after 0.02s, 0.04s and 1 hour.
Ten multimode glass fibers (n1 = 1.48, n2 = 1.45) are spliced together. Each fiber is 2 km long and has a loss rate 2-dB/km. Each splice adds 1 dB of loss. If the output power of the source is 7 dBm and radiates uniformly in a 60 degree half cone
A binary data stream needs to be transmitted at 5 Mbit/s by means of binary signaling. To reduce ISI, a cosine roll-off pulse of roll-factor r = 0.25 will be used. Determine the minimum required bandwidth for this transmission
The tray heats up according to ut = c2?u + h(x, y) where h(x, y) = 5(1 - sin(8πy)) and c2 = 10-4. Assume that u = 200 along each edge. Find the steady state temperature distribution of the tray.
A waveform generator has been setup with a square wave output at 4.0kHz with a 81% duty cycle. If the peak-to-peak output amplitude has been set to 6.0V, with an offset of -1.0V, what is the maximum voltage of the output waveform
Methods used to eliminate noise from a spatio-temporal signal, Name and describe, in detail, 2 methods used to eliminate noise from a (spatio-temporal) signal. This question requires a clear, detailed explanation of the methods. Mathematical equation..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd