Why the highest head of the water in the excavation

Assignment Help Civil Engineering
Reference no: EM13321149

why the highest head of the water in the excavation is mathematically guaranteed to occur on the edge of the excavation. explain in mathematical and/or physical.

Reference no: EM13321149

Questions Cloud

What is the eutectoid cementite content of the sample : You have a steel alloy with a 1.00 wt% carbon content that is cooled to room temperature. What is the eutectoid cementite content of this sample
Find the horsepower delivered to the water by the pump : It leaves the pump through a 4-in-diamter pipe at 15 psi. Assuming that the suction and discharge sides of the pump are at the same elevation, find the horsepower delivered to the water by the pump.
Find the half life : A radioactive sample produces 5120 decays at one point in an experiment and 40.96 minutes later produces 320 decays per minute. What is the half life
Explain fe is oxidized and oxygen is reduced : Which one is true or false f) HCLO4 is an oxoacid g) the name of HCLO4 is chloric acid i) in the redox reaction 4fe(s) + 3O2 (g) ---2Fe2O3(s) Fe is oxidized and oxygen is reduced
Why the highest head of the water in the excavation : why the highest head of the water in the excavation is mathematically guaranteed to occur on the edge of the excavation. explain in mathematical and/or physical.
Explain the incorrect value and enter the correct value : The following measurements refer to the same solution, but one is incorrect. Identify the incorrect value and enter the correct value in the space below. Enter exponents using "e-notation
Changing the outcome : Changing the Outcome
Explain what was the initial molarity : 680 mL of a solution of unknown concentration is diluted to a final volume of 1700 mL where the concentration is found to be 1.2 M. What was the initial molarity
What is the length of the solenoid : A 17.0 m-long copper wire, 2.10 mm in diameter including insulation, is tightly wrapped in a single layer with adjacent coils touching, What is the length of the solenoid

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the fuel load density and the opening factor

A hotel room has a floor area of 10 m by 4 m and is 2.5 high and has a window which is 1.6 m high and 3 m wide. The room contains some furniture and other commodities containing 50 kg polyurethane with 25 MJ/kg and 350 kg wood with 18 MJ/kg.

  Power developed by the force for a block

The block has a mass of 150 kg and rests on a surface for which the coefficients of static and kinetic friction are 0.5 and 0.4, respectively. If a force F = (60t^2) N, where t is in seconds, is applied to the cable, determine the power developed ..

  Seepage velocity and estimating hydraulic gradient

The dye appears 14 days later in an observation well 75 ft away from the injection point. Compute the seepage velocity and estimate the hydraulic gradient in the aquifer if the porosity of the soil is 42%.

  Calculate the space-mean speed in mile per hour

If there are 50 vehicles on a 4000-ft highway lane and the average time headway between two adjacent vehicles is 2.2 seconds. A) Calculate traffic density in vehicle/mile (vpm) and average space headway in feet/vehicle (fpv).

  Calculate the total weight

Identical bricks 0.1m wide, and weighting 2kg are placed on a plate (assume the plate has neligible weight). Calculate the total weight (and force F required to balance the plate). How far from x=0 should F be placed so that the plate will not tip..

  Calculate amount of suspended solids accumulating each day

A sedimentation basin is used to remove suspended solids from a wastewater. The rate of flow of wastewater into the tank is 10 L/s, and the influent concentration of suspended solids is 200 mg/L.

  Calculate deformation of truncated equilateral steel pyramid

Calculate deformation of the truncated equilateral triangular steel pyramid. The pyramid has the height h of 156mm truncated at the top by 2mm and the base side s of 127mm.

  Determine the maximum allowable compressive force

(a) Determine the desired diameter of the disk. (b) If the rubber strain is not to exceed 0.2 in/in, determine the maximum allowable compressive force. Recall that the spring constant, k=Fx,or in terms of an axially loaded member

  Determine when did the construction start in china

The Three Gorges Dam in China will be the world's biggest when complete. When did the construction start

  Determine the angle of rotation and deflection at end a

An overhanging beam ABC is subjected to a couple MA at the free end (see figure). The lengths of the overhang and the main span are a and L, respectively. Determine the angle of rotation and deflection at end A.

  Determine the stresses in cables and deflections of points

The steel beam ABCD is simply supported at A (pin) and supported at B and D by steel cables each having a diameter of 12mm. A force of 20 kN is applied at point C. For steel, let E = 209 GPa.

  Determine the required length of super elevation runoff

A simple highway curve is planned to connect two horizontal tangents that intersect at sta. 2500 + 00.00 at an external angle of 52 degrees. For a design speed of 60 mi/hr and a curve radius of about 1.25 times the minimum allowable

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd