Why the circuit current decrease

Assignment Help Electrical Engineering
Reference no: EM13488323

Why the circuit Current (I) decrease, when Inductance (L) or inductive reactance (XL) increases in inductive circuit?

Reference no: EM13488323

Questions Cloud

Does the large job shop become less expensive : At what Volume does the large job shop become less expensive than the small job shop?
The two strategies will generate the highest overall profits : The two strategies will generate the highest overall profits?
Purchase rate cost of contact : The CFO and want to determine whether or not the sales manager has a valid argument. After gathering and analyzing the data, you have come up with the following numbers
Innovation and the realities of the current economy : The realities of today's rapid technological innovation and the realities of the current economy, competitive advantage only exist for a short time and are quickly outdated.
Why the circuit current decrease : Why the circuit Current (I) decrease, when Inductance (L) or inductive reactance (XL) increases in inductive circuit?
An air-cored torus with a square cross section : A coil of 5000 turns is wound in the form of an air-cored torus with a square cross section. The inner diameter of the torus is 60 mm and the outer diameter is 100 mm. The coil current is 0.25 A.
Find the value of burnt resistor : How to find The value of Burnt Resistor ( By three handy Methods ) ?
What direction does the boat move relative : Jane ( 50 kg) and John ( 30 kg ) sit at opposite ends of a 5.0 m long boat (20 kg). Jane is on the left, John is on the right. When they trade sides, how far and in what direction does the boat move relative to where Jane was origin
The conversion of an incident pressure wave : The conversion of an incident pressure wave to an electrical signal is called?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Calculate the rectangular form of the four-point dft

Compute the rectangular form of the four-point DFT of the following signal, which is zero for n =4. Compute the inverse DTFT of: X(ω)=sinΩ cosΩ

  Determine what is the maximum allowable length of wire

An electrical device is designed to draw 4.0 amps. A 0.5 mm diameter copper wire is used to connect the device to a power source. What is the maximum allowable length of wire (in m), if the voltage across the wire is not supposed to drop by more t..

  Determine what is the current through each headlamps

Two identical automobile headlamps are connected across a 12v battery. if the total current from the battery is measured to be 6.5 A, what is the current through each headlamps

  Determine the wave equations for all three regions

a) determine the wave equations for all three regions b) what is K for each region c) using matrix algebra, determine the coefficients to the wave eaquation in region 2

  Determine change in regulated output voltage for situations

A shunt regulator utilizing a zener diode is biased on through a 100-ohm resistor. Determine the change in the regulated output voltage for the two situations below  a) VI changes +2.0 V, ILoad constant b) ILoad changes +100 mA, VI constant

  A painter is standing on a work platform that is 27 feet

1. a painter is standing on a work platform that is 27 feet above ground level. for fall protection the workers

  Find the relative speed between stator field and rotor field

A 4 pole, 3 phase induction motor is given a supply of frequency 50 Hz. Rotor speed is 1490 rpm. a) Find slip s b) The relative speed between stator field and rotor field c) Frequency of stator field and rotor field

  Determine how much energy is stored in the capacitor

A parallel-plate capacitor has capacitance 9.00 µF. (a) How much energy is stored in the capacitor if it is connected to a 9.00 V battery (b) If the battery is disconnected and the distance between the charged plates doubled

  How long does it take for sopranos voice to reach listeners

a) How long does it take for the soprano's voice to reach the listener b)In the same time interval, how far form the soprano has the sound wave in the auditorium traveled. Take the speed of sound to be 340 m/s.

  Design a second-order banpass filter with center frequency

Design a second-order banpass filter with center frequency f=10. The gain should be zero at t=0 and t= 8. Select poles at -a ±j10.  Explain the influence of a on the frequency response.

  For how long will the flash light provide illumination

A 9-V flashlight battery has a rating of 1.8 kWh. If the bulb draws a current of 100mA when lit: determine the following: (a) For how long will the flash light provide illumination

  Capture the counting system behavior as an hlsm

The system counts the number of events on a single bit input B and always outputs that number unsigned on a 16-bit output C, which is initially0. An event is a change from 0 to 1 or from 1 to 0. Assume the system count rolls over when the maximum ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd