Why nobody else bid on the light as it contains a 45-watts

Assignment Help Electrical Engineering
Reference no: EM13267302

attend a surplus electronics auction and buy a fancy spot light for the car. when you get home you realized why nobody else bid on the light as it contains a 45-watt, 9 volt bulb and your car ( like most ) has a 12-volt electrical system. you decide there is enough room in the light fixture to mount a resistor in series with with the light bulb.

Reference no: EM13267302

Questions Cloud

Discover and collect the traditional art forms : Imagine that you are one of these intrepid European explorers who has set out to discover and collect the traditional art forms created by the four cultures
Calculate the new depth of water in the conical tank : a closed conical tank with diameter of 1.50 and height of 3.00 m, sitting on its circular base has 1.00m depth of water. Suppose the tank is upside down and is made to stand vertically that way using some device.
Explain volume change is due entirely to the density change : If we assume that the volume change is due entirely to the density change (that is, neglect thermal expansion of the ice/water), what is the difference between the enthalpy change and the energy change during the process? Is this a significant dif..
What is the lowest frequency at which it will vibrate : A string is clamped at both ends and tensioned until its fundamental vibration frequency is 95Hz. what is the lowest frequency at which it will vibrate
Why nobody else bid on the light as it contains a 45-watts : attend a surplus electronics auction and buy a fancy spot light for the car. when you get home you realized why nobody else bid on the light as it contains a 45-watt, 9 volt bulb and your car ( like most ) has a 12-volt electrical system.
How much energy each capacitor stores : Two of the same capacitors C are wired in series. When they are connected to a +30V battery, How much energy each capacitor stores
Explain working solutions of bsa : Diagram the most accurate procedure so you end up with at least 500 uL each of 5 ug/uL, 0.5 ug/uL and 0.05 ug/uL working solutions of BSA.
Calculate location and lateral magnification of the image : If an object is located at 0.5 times the focal length of a thin lens, calculate the location and lateral magnification of the image. Assume that both sides of the lens are filled with air, that the index of refraction of the lens is n=1.5
What is the new volume of the balloon : A weather balloon filled with helium gas has a volume of 279 m3, What is the new volume of the balloon

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the suitable size of cable for electrical wiring

How to determine the suitable size of cable for Electrical Wiring Installation and please with Solved Examples.

  Calculate the data value and address location

1.Given S-DOman transfer function H1(s)= 1/(s+2). What is the time response H1(t). 2. Given H2(s)= (2s+5)/(s^2 +3S+2), what is h2(t) 3. Calculate the data value and address location for the following 8-bits date: 01111011 Buss address 10110011

  Determine the bibo stability of the given system

Consider a causal LTI (Linear-time invariant) system described by the following differential equation: \(\frac{d^2}{dt^2}y(t) + 5\frac{d}{dt}y(t) + 6y(t) = \frac{d}{dt}x(t) + x(t)\) a) Determine the transfer function of this system.

  Design lawn sprinkler system to water the lawn of residence

Assume that this whole system is linear, so that, if the pressure on a sprinkler is halved, the area covered (as well as the flow rate) will be halved. This is true until the pressure is reduced below 20psi, at which it does not work at all.

  Design a voltage-divider network to supply the load

The voltage across the load must remain between 4.7 and 5.0 V for all values of load current. Design a voltage-divider network to supply the load. You may assume that resistors of any value desired are available.

  Determine the output voltage for op-amp comparator circuit

Determine the output voltage for an op-amp comparator circuit with a non-inverting input reference voltage of + 2 VDC and an inverting input signal of - 1 VDC. The op amp reaches output saturation voltages of + or -13 V at the limits.

  Provide the complete code-word including the checksum

The 24-bit data field of a packet is given by 0xBC603F. The packet contains a CRC with the generator polynomial given by X 3+X+1 a) Find the CRC checksum. Provide the complete code-word including the checksum in hex.

  Rc circuits: capacitor is completely discharged

Assume that capacitor is completely discharged when t

  What is the uncertainty in position of an electron

What is the uncertainty in position of an electron of an atom if there is ± 2.0 x 10^7 m·sec-1 uncertainty in its velocity Use the reduced Planck's constant and electron mass = 9.109 x 10-31 kg.

  Find the corresponding thevenin voltage and norton current

When a 100-k load is connected to a signal source, the output voltage is 30 mV. If a 10- k resistor is used to load the same signal source, the output voltage is observed to be 10 mV. Find the corresponding Thevenin voltage, Norton current

  Calculate the built-in voltage of a junction

Calculate the built-in voltage of a junction in which the p and n regions are doped equally with 10^16 atoms/cm3. Assume ni =.5x10^10/cm^3.  With the terminals left open, what is the width of the depletion region

  How to use the minimum number of bits to represent the data

One of the biggest challenges with log systems, like the ones used for Intrusion Detection Systems data, is the amount of disk space that they require. For example, storing a message like: "User1 login success", contains 19 characters

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd