Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1. What is the purpose of core in hollow solder wire?
2. What is tinning, and why is it important?
3. Why is safety so important when soldering?
4. Why has lead-free solder replaced lead-based solder? Be sure to properly cite any sources of information.
A HCS12 ATD is set to 10-bit unsigned mode. The voltage references are set to ground and 1.0V What is the ADT output for a temperature of 81 degrees The temperature sensor measures 0 to 100 degrees with an output of 10 mV/degree.
What happens to an ECG signal when a triggered average is applied I can see from the graphs that the peaks directly before and after the triggered peak become more and more blurry, but I don't understand
Three resistors R1, R2 and R3 are connected in series and a supply voltage of 240 V. If R2 = 2R1, R3 = 3R1 and the total power taken by the circuit is 480 watts. Calculate the power in each resistor.
What should the signal definitions be for the equations, such that the minimal about of hardware (gates) are used assuming we have an abundance of NAND gates Show the signals definitions and resulting circuitry.
A coil of 2000 turns surrounds a flux of 5 mWb produced by permanent magnet. The magnet is suddenly withdrawn causing the flux inside the coil to drop uniformly to 2 mWb in 1/10 of a second. What is the voltage induced.
Racecar A is traveling on a straight portion of the track while racecar B is traveling on a circular portion of the track. At the instant shown, the speed of A is increasing at the rate of 10 m/s2, and the speed of B is decreasing at the rate of 6..
design the sign extension component of an I-Format Data Path Unit, where a 16 bit number will be extended to a 32-bit number, while mainintaing the sign (signed numbers use 2s complement).
Looking at feedback and some Opamp problems, If the unity gain frequency is 5 MHz and the midband open-loop voltage gain is 200,000, what is the cutoff frequency?
A certain magnetic core has a core loss of 8.4 W, of which one-third is eddy current loss, when the magnetizing field is changed 60 times a second. determine the core loss if the magnetizing field is changed only 50 times a second.
To analyze electric circuits, it is often necessary to solve simultaneous equations. To find the voltages Va, Vb, and Vc at nodes a, b, and c, the equations are 2(Va-Vb) + 5(Va-Vc) - e^(-t) =0 2(Vb-Vc) + 2Vb + 3(Vb-Vc) =0
In US, electric wires are classified based on their gauge numbers. The larger the gauge number is, the smaller the diameter of the cross-section of the wire becomes. You are given four different types of wire with gauge numbers 1, 3, 7, and 8.
Compute the correlation coefficient of two channels with frequency separation of 100 kHz and temporal separation 5 ms. Assume that the maximum Doppler shift of the channels is f_d=kv=100Hz and the rms delay spread is S_tao=1 µs.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd