Why does the electron gain or lose energy

Assignment Help Electrical Engineering
Reference no: EM13227144

The charge carried by an electron is ?1.60×10?19 C. Suppose that an electron moves through a voltage of 120V from the negative polarity to the positive polarity. How much energy is transferred? Does the electron gain or lose energy?

Reference no: EM13227144

Questions Cloud

Explain what kind of standard is y : A solution containing an unknown amount of X and 10.25 mM of Y was run and gave peak areas of 8.20 and 6.50 cm2 respectively. What is the concentration of X in the unknown solution? What kind of standard is Y?
Determine the cost per kilowatt hour for the energy : Determine the cost per kilowatt hour for the energy delivered by a typical alkaline 9-V "transistor" battery that costs $1.95 and is capable of delivering a current of 50 mA for a period of 10 hours. (For comparison, the approximate cost of energy..
Compute the molar mass of the unknown gas : Calculate the molar mass of the unknown gas. (Remember that the faster the rate of effusion, the shorter the time required for effusion of 1.0 L; that is, rate and time are inversely proportional.)
How much charge must move through the battery : A certain battery has terminals labeled a and b. The battery voltage is vab = 12 V. a) To increase the chemical energy stored in the battery by 600J, how much charge must move through the battery
Why does the electron gain or lose energy : The charge carried by an electron is ?1.60×10?19 C. Suppose that an electron moves through a voltage of 120V from the negative polarity to the positive polarity. How much energy is transferred Does the electron gain or lose energy
Define what is the partial pressure of each component : A mixture of gases contains 2.89 g of N2, 5.38 g of H2, and 9.00 g of NH3. If the total pressure of the mixture is 2.24 atm, what is the partial pressure of each component?
Describe five potential challenges to starting : You are planning to begin a new business providing legal consulting services to the technology industry. Name and describe five potential challenges to starting this new business.
How the gps could be used for the propagation of signals : Build a C++ code for vehicle sensing device. Code is required to embed in the device so that then it must sense the location where the vehicle is currently present. The device must be able to track the location of the vehicle for its owner
Determine what is the phase angle in degree : an electric motor has an armture constant of 140, a flux of 25 mwh, an armuture current of 30 A , and a rotatio?nal speed of 1600 rpm. what is most nearly the power output in watt

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Draw a band diagram

Calculate the Fermi level position relative to conduction band (Ec-Ef) and relative to valence band (Ef-Ev).

  Find the component of q at p in the direction of pt

(a) Determine a unit vector in the direction of Q at P(1, 2, 1) (b) Find the component of Q at P in the direction of PT where T is point (5, 3, -4) (c) Where is Q the same as the unit vector of  \(a_{x}+11a_{y}+10a_{z}\)

  How to generate odd parity over the individual words

Design a system using either a flow diagram or pseudo code that will accept a block of data words encoded as specified in Part 1; then check the parity for each data word and for the block. The system should output each of the 8-bit data words.

  Determine the voltage regulation at rated load

A 75-kVA, 230-V/115-V, 60-Hz was tested with these results: Open-circuit test: 115 V, 16.3 A, 750 W; Short-circuit test: 9.5 V, 326 A, 1200 W a) Determine the voltage regulation at rated load, 0.8 power factor lagging.

  Explain construct a table showing the current for values

Construct a table showing the current for values of time between 0 and 9 hours at intervals of 1 hour.Hence draw a graph of i against t for 0 is smaller or equal to t is smaller or equal 9.(cannot type in proper inequality symbols)

  Construct the adder for 2 digit decimal numbers

Construct the adder for 2 digit decimal numbers presented in BCD code. 4 bit binary adders and additional logical gates. The BCD adder for each decimal digit can be implemented with two 4 bit binary adders where the second adder.

  Determine the corediameter required for the fiber topermit

determine the corediameter required for the fiber topermit its operation over the wavelength range 1.48 to 1.60um. calculate the new fiber core diameter to enable single mode transmission at a wave length of 1.30um.

  What is the particular solution for capacitance current

In a series RC circuit, R = 5 Ohms and C = 0.1F. The capacitor voltage is 10 volts at t=0. At t=0, a voltage of 4V is applied. a) Determine the total capacitance voltage and capacitance current as a function time after the external voltage is applied..

  Calculate the mass of the cooling water in a minute

an electrical transformer dissipates heat equivalent of 3000 kW/h. the inlet and outlet temperatures of the cooling water are 55C and 15C respectively. calculate the mass of the cooling water in a minute.

  Explain the function of frequency dial and frequency range

explain the function of frequency dial and frequency range.

  . identify each system as either undamped or overdamped

The following 4 differential equations describe mass spring systems. Identify each system as either undamped, overdamped, underdamped, or critically damped (Justify your answer). Determine the angular frequency and period for the undamped

  Define wireless networks

You want to download a 5 Mbit file over a 10-Mbps Rayleigh fading channel in the 1800 MHz frequency band. You are traveling at 6 km/h and use 1000-bit packets.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd