Which would require less wood and by what percentage

Assignment Help Civil Engineering
Reference no: EM13299586

An engineer is to design a channel lined with planed wood to carry 2 m3/s of water on a given slope. The channel cross section can be either a 90 degree triangle or a square. Which would require less wood and by what percentage?

Reference no: EM13299586

Questions Cloud

Calculate the level at tpl of a vertical crest curve : A vertical crest curve has an approach grade +6% and a departure grade -6%. The Vertical intersection point level is 125 m. It is proposed to use a curve 720 m long. Calculate the level at TPl.
Develop an estimate of the volumetric flow rate of air : Develop an estimate of the volumetric flow rate of air that will be required for aeration of the mixed liquor in an activated sludge system.For this calculation, assume that the (ultimate) CBOD is 200 mg/L and (ultimate) NBOD is 50 mg/L.
Determine the dead load per unit of length on a beam : A floor system consists of wide flange steel beams (W18 x 60) equally spaced at 8ft center to center. A 6inch reinforced concrete slab spans between beams. The bottom of the slab is coated with plaster and the top of the slab has ¾inch hardwood fl..
Determine properties of the material poissons ratio : At the proportional limit, . gage length of a -diameter alloy rod has elongated . and the diameter has been reduced . The total tension force on the rod was . Determine the following properties of the material
Which would require less wood and by what percentage : An engineer is to design a channel lined with planed wood to carry 2 m3/s of water on a given slope. The channel cross section can be either a 90 degree triangle or a square. Which would require less wood and by what percentage
Calculate weight of water added to reach the saturation : A soil sample with a volume of 0.5 m3, dry unit weight = 18.1 kN/m3, water content = 5%, and Specific Gravity of the soil solids = 2.68. Calculate weight of water added to reach 90% saturation (in kilograms)?
If allocation c is pareto efficient but allocation d is not : A policy may yield a Pareto superior outcome so long as the gains to those who benefit are greater than the losses to those who are worse off.
Design a suitable pavement consisting of a granular subbase : if the subgrade has a resilient modulus of 103,500kN/m2, design a suitable pavement consisting of a granular subbase with a layer of coefficient of 0.13, a granular base layer with a layer coefficient of 0.14, and an asphalt concrete surface with ..
Diminishing returns to a single factor of production : An increase in the price of an input leads to higher costs and therefore less profit at the original quantity produced; therefore, some firms will increase the quantity they produce in order to increase revenues.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the speed of both cars just after coupling

the 15,000 kg boxcar A is coasting freely at 1.5 m/s on the horizontal track when it encounters a tank car B having a mass of 12,000 kg and coasting at 0.75 m/s toward it. If the cars meet and couple together

  Define need before function

Which of the following is not a basic systems engineering concept?a. Define need before function

  Compute normal and critical depths in a concrete culvert

compute normal and critical depths in a concrete culvert(n=0.015)with a diameter of 36in.and a bed slope of 0.002ft/ft if the design discharge is 15cfs.is the slope steep or mild?reap for S= 0.02ft/ft.

  Find which is produced with emphasis on temporal distributn

You are assigned the task of using bioremediation to cleanup a hazardous waste site contaminated with Tetrachloroethylene. The site is a shallow surficial sandy aquifer 30 feet deep underlain by a clay unit. The depth to the watertable is 10ft.

  Principle of lateral continuity

Would you expect to find the Tapeats Sandstone on top of the Great Unconformity in all places in the Grand Canyon? Why, or why not?

  Estimate the wet density

A sample of natural glacial till was taken from below the groundwater table. The water content was found to be 52%. Estimate the wet density,dry density,buoyant density,porosity,and void ratio. Clearly state any necessary assumptions.

  Conductive heat loss through the furnace wall

Assuming unit surface area, find the conductive heat loss through the furnace wall and the temperature at the interface of the fire clay and red brick.

  Determine the practical moment strength phi-msubn for steel

determine the practical moment strength phi x Msubn for a rectangular reinforced concrete cross section having a width (b of 13 in.) and an effective depth (d of 24 in.) The tension reinforcing steel is four no# 8 bars.

  Determine what is the drag coefficient of a 3000-lb car

A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16-inch-radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is known that at the car's top speed the engine is producin..

  What is the angle of inclination of the plane

A body slides down a frictionless plane and during the third second after starting from rest if it travels 20.4m. What is the angle of inclination of the plane?

  Source and destination addresses of router solicitation

Source and destination addresses of router solicitation, Given an IPv6 network, assume a host using EUI-64 addressing has a MAC address of00:24:E8:3D:CA:35

  Determining stress fort rigid bar of negligible weight

The rigid bar of negligible weight is supported as shown. Find the stress in each rod if the temperature rises DeltaT after a load P is applied. Use the following data: area of steal rod 320mm2, bronze rod 1300mm2, thermal expansion coefficient Al..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd