Which type of i-o has disadvantage to part of address space

Assignment Help Electrical Engineering
Reference no: EM13295017

Which type of I/O has the disadvantage that part of the address space must be given up to implement I/Oports?

Reference no: EM13295017

Questions Cloud

What is the cost to the fdic : What is the cost to the FDIC if the insured depositor transfer resolution method is used by the regulators to resolve the bank failure?
Determine what are the electron and hole velocities : Electrons and holes are moving in a uniform, one-dimensional electric field E = +2500 V/cm. The electrons and holes have mobilities of 700 and 250 cm2/V · s,respectively. What are the electron and hole velocities If n =1017/cm3 and p =103/cm3
Compute the angular speed of the rod : A uniform rod of mass 3.35×10?2kg and length 0.430m rotates in a horizontal plane about a fixed axis through its center, What is the angular speed of the rod after the rings leave it
To what height would the blade rise : A lawn mower has a flat, rod-shaped steel blade that rotates about its center. The mass of the blade is 0.59 kg and its length is 0.50 m. to what height would the blade rise
Which type of i-o has disadvantage to part of address space : Which type of I/O has the disadvantage that part of the address space must be given up to implement I/Oports
What is the position of the front of the train : a 100 sec long train (as measured at rest) moves in the x-direction with speed B=4/5. what is the position of the front of the train when the rear light is turned on, according to an observer on the ground
What is forecasting risk : What is forecasting risk? In general, would the degree of forecasting risk being greater for a new product or a cost-cutting proposal? Why?
Explain correspon to the values for the gas constant : Use the Ideal Gas Law in the form n=PV/RT. Remember to change all units to correspon to the values for the gas constant. R=0.0821 L*atm/mol*K.
Calculate its net present value and internal rate of return : The tax rate is 35%. The company has a required return of 14%. Calculate its net present value and internal rate of return.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is the gain in db for the amplifier at that frequency

An amplifier has a power gain of 3dB and an input signal power P(In) = 100mW. What is the output power level A tank circuit coil is operating at a resonance frequency f(res) = 20 MHZ; The circuit must operate with a bandwith of 200 KHZ.

  Determine the counter emf of a shunt motor armature

a certain shunt motor armature has a resistance of 0.07 and a current of 50 amperes at 120 volts. determine the counter emf

  What would be the degree and the values of coefficients

Inverse Z-transform and poles and zeros. When finding the inverse Z-transform of functions with z-1 terms in the numerator, the fact that z-1 can be thought of as a delay operator can be used to simplify the computation.

  Determine the line current in the circuit if the angle 0 deg

A positive-sequence balanced three-phase wye-connected source witha phase voltage of 120 V rms supplies power to a balanced wye-connected load. The per phase load impedence is 40 + 10JΩ.

  For how long would device tie up bus when transferring block

Consider a system in which a data transfer over a bus takes 500 ns. Transfer of bus control in either direction, from processor to I/O device or vice versa, takes 250 ns. One of the I/O devices has a data transfer rate of 50 KB/s and employs DMA.

  Determine the current that would flow in the resistor

If you had the 6V supply set toits full voltage and set so that the maximum supply current is 5A,use Ohm's law to fill in the following two blanks: a. If a 1kOhm resistor wereconnected across the 6V supply's terminals

  What are the names of the three regions of the bipolar

What are the names of the three regions of the bipolar junction transistor? Why is there a thin region of one material type

  Design a sine wave oscillator using the op-amp

Design a sine wave oscillator using the op-amp that provides the output signal with amplitude of 4V to 6.5V and a frequency of 1kHz.

  Find the number of poles in the machine and generator

A three phase motor is connected to a 60Hz electrical source. The motor spins at 600rpm. Find the number of poles in the machine. The output of the above motor is connected to the input of a generator.

  What is the length of aluminum conductor of the same area

A coil of copper wire (ρ=10.37 micro-ohm-CM/ft) hasa length of 182.88 meters. What is the length of aluminum conductor(ρ=17 micro-ohm-CM/ft) of the same area and resistance asthose of copper coil

  Problem on transmission line operation

Evaluate the TL parameters. Include the effect of the earth as ideal. Do not incorporate the effect of the shield wires.

  Determine a suitable diameter and length of the rod

An LVDT Is used to measure the axial deformation a simple bar.The uncertainty in this measurement is ± 0.025mm. A steelbar is to be used to measure a force of 1100N with an uncertaintyof 1 percent.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd