Which system should be chosen

Assignment Help Chemical Engineering
Reference no: EM131061588

An engineer in charge of the design of a plant must choose either a batch or a continuous system. The batch system offers a lower initial outlay but, owing to higher labor requirements, exhibits a higher operating cost. The cash flows relevant to this problem have been estimated as follows:

979_048520f9-3937-401b-9a33-3c907b41f311.png

Check the values given for the discounted-cash-flow rate of return and net present worth. If the company requires a minimum rate of return of 10 percent, which system should be chosen?

Reference no: EM131061588

Questions Cloud

How many years of useful life should be estimated : How many years of useful life should be estimated for the reactor if 12 percent of the total annual expenses for the plant are due to the cost for reactor depreciation? The straight-line method for determining depreciation should be used.
Associate the features of audience-purpose : Associate the features of audience, purpose, and text with various genres. Recognize the elements and correct use of a thesis statement. Recognize how to organize ideas with transitional words, phrases, and sentences.
Determine the following depreciation charge for the fifth yr : The percent of the original investment paid off in the first half of the service life using the sum-of-the-years-digits method.
Literacy development through phonemic awareness : What is the difference between phonemic awareness and phonics? Describe how a teacher can promote early literacy development through phonemic awareness.
Which system should be chosen : Check the values given for the discounted-cash-flow rate of return and net present worth. If the company requires a minimum rate of return of 10 percent, which system should be chosen?
Determine the mean wage rate using the raw data : Determine the mean wage rate using the raw data. Draw an OGIVE curve corresponding to the data and use it to estimate the median
What replacement return on his capital investment will the o : All other expenses except depreciation would be unchanged. If the old canning unit can be sold for $600, what replacement return on his capital investment will the owner receive if he decides to make the replacement?
Administrators notify authorities : When teachers or administrators notify authorities about possible abuse or neglect, they must also inform the individual or family suspected of this behavior.
Construct and submit frequency distribution of the data : Construct and submit frequency distribution of the data. Show classes, midpoints for each class, frequencies, relative and cumulative frequencies.

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Gold has a face centered cubic crystal structure where

gold has a face centered cubic crystal structure where there are four atoms per unit cell.below is a calculated xrd

  Gaseous diffusion process

The fluoride mixture is then enriched through a multistage diffusion process to produce a 3% 235U nuclear fuel. The diffusion process utilizes Graham's law of effusion (see Chapter 5, Section 5.7). Explain how Graham's law of effusion allows natur..

  Determine the composition of the vapor

Determine the composition of the vapor at boiling point and determine the Dew point of the mixture - determine the composition of streams leaving the first FV unit.

  Result in a loss of production

The estimated cost of the pipes, per unit length is: schedule 40 carbon steel $5, schedule 80 carbon steel $8.30, stainless steel (304) schedule 40 $24.80. Installation and fittings for all the materials adds $16.5 per unit length. The downtime re..

  Design a hydro cyclone system to handle

A recovery of 95% of particles greater than 100 μm is required. The minimum operating temperature will be 10 °C and the maximum 30 °C. Design a hydro cyclone system to handle 1200 liters/min of this slurry.

  Concentration of the original lead

You decide to take 2.00 mL of the solution and add an excess of a concentrated sodium chloride solution. You obtain a solid with a mass of 3.407 g. What was the concentration of the original lead(II) nitrate solution?

  Activate a shutdown trip

a. What alarms would you add to the vaporizer control scheme shown in Figure? Indicate whether the alarm would signal high or low conditions, what the alarm would signify, and what operator response would be required in each case.

  Question 1suppose the system shown below initially the gas

question 1suppose the system shown below. initially the gas is at 200 kpa and occupies a volume of 0.1 m3. the spring

  Design the most efficient centrifugal pump

Design the most efficient centrifugal pump that produces 200 gpm (45.5cumeters/hr) water flow rate at 100 psi (680 kPa) head. Specify the impellor diameter and width for a 3400 rpm service.

  How is the ph level maintained in biological systems

List out the different biological process involving acids and bases with relevant equations and in adverse conditions how is the pH level maintained in biological systems?

  Define grams of tin and lead

Grams of tin and lead, An alloy is 7 parts tin and 3 parts lead. How many grams of each are in 40g of the alloy? Let x= the number of grams of tin in the 40g of the alloy.

  What is the pressure at the azeotropic composition

At 50 °C the system acetone(1) and chloroform(2) forms an azeotrope with composition x1 = 0.416. What is the pressure at the azeotropic composition at 50 °C?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd