Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Which signal travels fast? Analog or digital
A 150 MVA, 24 kV, 123% three-phase synchronous generator operates with an induced voltage that is twice the rated line-to-neutral voltage. Calculate the three-phase steady-state short-circuit current at the generator terminals.
In a RLC circuit, the generator voltage varies in time, where the amplitude of e max= 1.2 volt and emf freq.= 0.5 Hz , which the max current is equal to the max current when the freq. of emf = 3.0 Hz, which is .00033 A.
Describe the two spin echo methods (1.Hahn, 2. CPMG-Purcell et. al). Describe the role of p/2 and p pulses in each case and make a comparison and contrast. Give diagrams
the bipolar transistor inverter circuit demonstrated below uses there a supply voltage of vcc 5v. ltbrgt
Compare the maximum theoretical PCE for 980-nm and 1475-nm pumping in an EDFA for a 1545-nm signal. Contrast this with actual measured results of PCE = 50.0% and 75.6% for 980-nm and 1475-nm pumping, respectively.
Draw the circuit and discuss the operation of SA type ADC. Determine the conversion time of an SA-ADC for 12-bit resolution,at 2.5 MHz.
Saturated and unsaturated synchronous reactance, The following readings are taken from the results of an open- and a short-circuit test on a 9375-kVA three-phase Y-connected
Two full charged 8A-Hr batteries are connected in parallel and supply power to a resistive load of 2.4 ohms. The open-circuit voltage of both batteries is 6.4VDC and the internal(Thevenin) resistances are 0.24 ohms and 0.28ohms.
An angle-modulated signal with carrier frequency ???ωc=2πx106 is described by the equation φEM(t) =10cos(ωct +0.1sin200πt) (a) find the power of the modulated signal. (b) find the frequency deviation Δf. (c) find the phase deviation ΔΦ.
a 220v shunt motor driving its normal load draws an armature current of 50A. The armature resistance is 0.25ohm. determine the armature current it will draw when connected to 200V source while maintaining the armature speed and the flux per pole.
A copper stripline transmission line is to be designed for a 592 OHMS characteristic impedance. The ground plane separation is 1.02 mm and the dielectric constant is 2.20, with tan = 0.001.
An Aluminum electrolytic capacitor that has a capacitance of 75,000µ F,100WV is used in a power supply circuit. The leakage specification of this type of capacitors is 5µ A/µ F. If the voltage across this capacitor is 50 volts, what will be the le..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd