Which reactor is more efficient and why

Assignment Help Civil Engineering
Reference no: EM13555198

There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively. Which reactor is more efficient and why? If all these are CMFR reactors, how can you increase the performance of the least efficient reactor?

Reference no: EM13555198

Questions Cloud

Determine for the crest and sag vertical curves required : Two level sections of an east-west highway (G = 0) are to be connected. Currently, the two sections of highway are separated by a 4000-ft (horizontal distance), 2 % grade.
Find bottles contain tablets for thyroid : An overnight shipment contains 2 bottles of Aspirin and 3 bottles of thyroid tablets. A second shipment contains 3 bottle of aspirin, 2 bottles of thyroid and 1 bottle of laxative tablets. If one bottle is randomly chosen from each of the two shipmen..
How much water can you leave in the tank to be reasonably : As a result of a promotion, you are transfered from your present location. you must transport a fish tank in the back of your car. the tank is 12 in by 24 in by 12 in(height is 12in).
What is the concentration of salt in the stream after the : A storm sewer is carrying snow melt containing 1200 mg/L of NaCl into a small stream. The stream has a naturally occurring NaCl concentration of 20 mg/L. If the storm sewer flow rate is 2000 L/min and the stream flow is 2.0
Which reactor is more efficient and why : There are three reactors degrading a chemical biologically, at three degradation rates; i.e., 0.2 d^-1, 0.4 d^-1, and 1.0 d^-1. The residence time of the chemical in these reactors are 10 d, 5 d, and 55 d, respectively
Determine the crest height of a suppressed weir that should : A weir is to be installed to measure flows in the range of 0.5 to 1.0 m3/sec. If the maximum (total) depth of water that can be accommodated at the weir is 1m and the width of the channel is 4m, determine the crest height of a suppressed weir that sh..
How much water in cubic feet has been pumped out of storage : If the head in the Jordan has been pumped down by 100 ft in recent times, how much water in cubic feet has been pumped out of storage for an area of 100 sq. mi.?
Determine the maximum water table elevation : A canal was constructed running parallel to a river 1500 ft away. Both fully penetrate a sand aquifer with a hydraulic conductivity of 1.2 ft/d. The area is subject to rainfall of 1.8 ft/y and evaporation of 1.3 ft/y. The elevation of water above the..
What is the optimal distance between the two drainage : To avoid the salinization of soil in a farming area, parallel drainage canals are to be installed to maintain the water table at a depth of at least 4m below the ground surface.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine if its possible to pull at p without causing wheel

If the coefficient of sratic friction between the wheels at B and the ground is 0.5 determine if it is possible to pull at p=1200 lb without causing the wheels at B to slip or the front wheels of A to lift off the ground

  Determine the theoretical discharge

A vertical triangular orifice in the wall of a reservoir has a base 0.9m long,0.6m below its vertex and 1.2 m below the water surface. Determine the theoretical discharge?

  If the desired flowrate is at least

Two reservoirs, which differ in surface elevation by 40m, areconnected by 350m of new pipe of diameter 8cm. If the desired flowrate is at least 500N/s of water at 20 degrees C. can the pipematerial be made of

  Calculate average f per m using an mlss of 1000 mg per l

Wastewater flow is 80 gpcd with 170 mg/l BOD and 190 mg/l suspended solids. Size the extended aeration basin and clarifier using the minimum detention time and overflow rates. Calculate the average F/M using an MLSS of 1000 mg/l.

  What is probability that clearance meets the specifications

The diameter of the hole is normally distributed with a mean 15 cm and standard deviation 0.025 cm, and the diameter of the piston is normally distributed with mean 14.88 cm and standard deviation 0.015 cm.

  Determine the effluent soluble substrate concentration

Lab studies have shown that the rate constant associated with the process are as follows: k = 0.95 mg COD/mg VSS-day; Y = 0.48 mg VSS/ mg COD, half-saturation K = 85 mg COD/L; ke = 0.07 d-1.

  What would the diameter corresponding to percent removal be

a standard reverse-flow cyclone with a length of 5cm has a cut diameter of 250 microns. at a flow rate of 10^-7 m^3/s, what would the diameter corresponding to 90% removal be

  What is the min length for the off-ramp to provide storage

If the average length of a vehicle is 15 ft and the average space between consecutive vehicles waiting to be served is 3 ft, what is the minimum length for the off-ramp to provide storage for all exiting vehicles 80 percent of the time

  Determine the most economical alternative of return analysis

Using Rate of Return Analysis, determine the most economical alternative below. Assume a minimum attractive rate of return of 6%, and a 5-year life with no salvage value for each. The alternatives are mutually exclusive

  What is effect of packing factor in self compacting concrete

what is effect of packing factor in self compacting concrete?

  A photograph is taken of a transverse wave travelling along

a photograph is taken of a transverse wave travelling along a length of rope. at this instant the shape of the wave is

  What is nominal yearly interest rate on a loan with interest

what is the nominal yearly interest rate on a loan with quarterly interest of 3% with quarterly compounding

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd