Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Compare GBN, SR, and TCP(no delayed ACK). Assume that the timeout values for all three protocols are sufficiently long such that 5 consecutive data segments and their corresponding ACKs can be received (if not lost in the channel) by the receiving host (Host B) and the sending host (Host A) respectively. Suppose Host Asends 5 data segments to Host B, and the 2nd segment (sent from A) is lost. In the end, all 5 data segments have been correctly received by Host B.
a. How many segments has Host Asent in total and how many ACKs has Host B sent in total? What are their sequence numbers? Answer this question for all three protocols.
b. If the timeout values for all three protocol are much longer than 5 RTT, then which protocol successfully delivers all five data segments in shortest time interval?
A 150 KVAR capacitor is connected across the line in Problem 1. (a) Sketch and label the power triangle for the capacitor. (b) Sketch and label the power triangle for the combined loads (capacitor and motor).
calculate the resistor's resistance. If the bandwidth were cut to 25 kHz, determine the expected output meter reading.
BJT Amplifiers Sketch an emitter-follower circuit with R1 = R2 = 50kohm ; RE = 2kohm. The collector of the npn transistor is connected to VCC = 5V and the input signal has an internal resistance, RS = 0.5kohm
Simplify the following circuit. Line A goes into an INVERTER, then into a NAND Gate, then into an OR Gate, then travels into another NOR Gate.
a DC motor turns at a speed of 1460 rpm and produces an output torque of 3.0Nm. The DC voltage applied to the motor is 100V and a current of 5.1A flows through the motor. A. What is the efficiency of the motor
Two transistors, fabricated with the same technology but having different junction areas, when operated at a base-emitter voltage of 0.72 V, have collector currents of 0.2 mA and 12 mA. Find Is for each device.
The HL pair of 8085 microprocessor is loaded with 0505 H. The HL Pair is decremented to 000 H. Which flag will be affected (A)Z flag (B)C flag (C)No flag is affected (D)P flag 1.In a 8-bit Microcomputer having 8k bytes of RAM Memory,the length of sta..
An engineer decides to take 600 samples at sampling frequency 9000Hz. A Fast Fourier Transform (fft) program was applied to obtain the frequency spectrum of the signal. What is the frequency resolution,df, for the analysis
A 15 hp, 209V,three-phase,six pole, Y-connected induction motor has the following parameter values per phase: R1= 0.128 ohm, R'2=0.0935 ohm Xeq- X1 + X'2 = 0.49 ohm. The motor slip at full load is 3%, and the efficiency id 90%.
A 600V, dc shunt motor has an armature and field resistance of 1.5 ohm and 600 ohm, respectively. When the motor runs unloaded, the line current is 3A, and the speed is 1000 rpm.
1) 70 lbs/hr of steam at 300 psia, 500oF passes through a turbine which expands it to a pressure of 30 psia. If the turbine operates with an efficiency of 70%: a) What is the temperature of the steam leaving the turbine b) What is the quality (% v..
A three-phase load is Y-connected. The load has a phase voltage of 139 V and a phase current of 49 A. Each phase of the load consumes 5.1 kW of power. (A) Sketch and label the load. Find (b) the line voltage, (c) the line current, and
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd