Which of frequencies represents the pre-warped frequencies

Assignment Help Electrical Engineering
Reference no: EM13248551

design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies. Which of frequencies represents the pre-warped frequencies?

Reference no: EM13248551

Questions Cloud

Determine required sampling rate and line speed : Consider a PCM-TDM system in which 24 signals are to be processed. Each signal has a baseband bandwidth of 3 KHz. The sampling rate has to be 33.3% higher than the theoretical minimum, and 8 bits are to be used.
What are the weaknesses of a swot analysis : Why is it important to conduct a SWOT analysis? What are the weaknesses of a SWOT analysis? Why is that so?
Describe the final temperature of the mixture : An ice cube at 0 degrees C with a mass of 115 g is added to H2O in a beaker that has a temperature of 64.0 degrees C. if the final temperature of the mixture is 24.0 degrees C, what was the initial mass of the warm water
Why is it important to understand the external environment : Describe the elements of an organization's external environment. Why is it important to understand the external environment?
Which of frequencies represents the pre-warped frequencies : design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies.
What is probabilty that project will take less than 30 days : what is the probabilty that the project will take less than 30 days?
Explain water is sprayed on the ground of an orchard : a) water is sprayed on the ground of an orchard when temperatures are near freezing to keep the fruit from freezing. Explain b) How many kilojoules of energy are released if 5.0 kg of water at 15 degrees C is on the ground and cools and freezes at..
Explain the type of compound : Describe the type of compound that could have each of the following types of attractive forces: a) dipole-dipole attractions; b) Hydrogen bonding; c) dispersion forces.
Find the height max with respect to top of the trampoline : A girl of mass m 1 =60 m_1 = 60 kilograms springs from a trampoline with an initial upward velocity of v i =8.0 v_i = 8.0 meters per second, What is height max with respect to the top of the trampoline

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What amount required of memory in a real-time

select a window function to limit the number of samples of an infinite impulse response and the filter specifications are the same, regardless of which window function you select. If you are given the option of using either a Hamming

  Approximate the cutoff frequency of the opamp itself

b. If the opamp is configured as a non inverting amplifier with voltage gain of 100, what bandwidth will the circuit have c. With the same configuration (gain of 100), what is the maximum input for linear operation (limited by VCC)

  What is the gain formula for a non inverting op amp

The LM358 op amp can be a single or dual supply op-amp. This mean that it can operate with just a single supply i.e. + 5 volt or with dual supplies i.e. (+ and -) 5 volt supplies. With a inverting configuration with dual supplies (+5v and -5v) bei..

  Define addition of two numbers in ieee 754 format

Addition of two numbers in IEEE 754 format A) a=3f200000, b=be600000 B) a=3f200000, b=ff800000 C) a=01100000, b=80e00000

  Compute the battery life in years and months

An embedded system consumes the following current when in different operating modes: Operating Mode Avg. Current Time Data Acquisition 4.2 mA 1.8 ms Communication 22.6 mA 2.5 ms Sleep Mode 0.5A 5 hours

  Find the speed of the motor for a line current of 20 a

A 230 V DC series motor has an armature circuit resistance of 0.2 and a eld circuit resistance of 0.1. At rated voltage, the motor draws a line current of 40A and runs at a speed of 1000 rpm.

  Explain what is the fundamental frequency of the spectrum

What is the fundamental frequency of the spectrum of the square wave? What is the magnitude of the fundamental frequency component of the spectrum of the square wave?

  Determine the minimum order of the filter at sampling rate

the -3 dB frequency for low pass Butterworth filter is 2.5 kHz. The stop band begins at 3.8 kHz, with an attention of 35 dB. Determine the minimum order of the filter if the sampling rate is 8 kHz

  Determine what is the maximum height of the stadium

Ted Williams hits a baseball with an initial velocity of 120 miles per hour (176 ft/s) at an angle of f = 35 degrees to the horizontal. The ball is struck 3 feet above home plate. You watch as the ball goes over the outfield wall 420 feet away

  Determine the induced emf in the rotating loop

A rectangular loop of wire containing a high resistance voltmeter has corners initially at (a/2, b/2, 0), (-a/2, b/2, 0), (-a/2, -b/2, 0) and (a/2,-b/2, 0). The loop begins to rotate about the x axis at constant angular velocity w.

  Build a home security system circuit using program

Build a home security system circuit using this program. The system must include 2 door sensors, 3 window sensors, 2 smoke detectors, 2 water leak sensors, and 2 motion detectors.

  Design a binary counter capable of counting

The counter should increment on the rising edge of an input signal we'll call COUNT. Another input called CLEAR should have the effect of setting the counter to zero if CLEAR = 1 when COUNT is asserted.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd