Which is the maximum noise allowed in the receiver

Assignment Help Electrical Engineering
Reference no: EM13254707

A radio link receiver has a signal sensitivity of 100 milliwatt. The SNR required is at least 14 dB. Which is the maximum noise allowed in the receiver.

Reference no: EM13254707

Questions Cloud

Chose an organization which is widely known : Choose an organization which is widely known and write a 5-7 page Business Plan.
Calculate the electric potential at given height : The naturally occurring charge on the ground on a fine day out in the open country is -1.00 nC/m2.  Calculate the electric potential at this height
Which is the maximum attenuation in db allowed : The transmitter has a power of 7 watts and the receiver needs at least 266 milliwatts to operate. Which is the maximum attenuation in dB allowed (value must be negative)
Analyze 14th amendment which claims equal protection : What are the three level of scrutiny used to analyze 14th amendment which claims equal protection?
Which is the maximum noise allowed in the receiver : A radio link receiver has a signal sensitivity of 100 milliwatt. The SNR required is at least 14 dB. Which is the maximum noise allowed in the receiver.
The phosphate ion forms insoluble precipitates with calcium : The phosphate ion forms insoluble precipitates with calcium and magnesium ions, removing them from solution. Suppose that a solution is 4.5×10?2 in calcium chloride and 8.5×10?2 in magnesium nitrate.
Develop an objective analysis : The missing piece we need is Earned Value (i.e. what we have actually accomplished so far). You meet with your team and find that only 6 of the 7 tasks scheduled to be complete by the end of month 4 have actually been completed.
Calculate the total number of kbps needed in the adc : An analog signal has a bandwidth of 37 kHz and must be digitized in an ADC. The peak voltage is 7V and you need to maintain a resolution of 0.078V. Find the number of bits per sample and then
Explain lightning from thunderstorms strike the earth : Lightning from thunderstorms strike the Earth 100 times each second. 2400 deaths have been caused by lightning strikes over the past 25 years. How many strikes occur before a death occurs

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Do specify the requirements on the adc

A calibrated RTD with ALPHA = 0.0041/°C, R = 306.5 Ohms at 20°C, and PD = 30 mW/°C will be used to measure a critical reaction temperature. Temperature must be measured between 50° and 100°C with a resolution of at least 0.1°C.

  Find the surface temperature in k of the computer chip

For computer chip of 10mm (length), 5 mm(width) is operated by power of 0.645 watt, which surrounded by coolant material of temp of 80 F. Find the Surface Temperature in K of the computer chip during the heat transfer of convection.

  Draw the sympol and truth table of the gate

draw the sympol and truth table of the gate that corresponds to the action of the logic gate.

  Find the rms current into the motor

A 450 kW motor operating 73% Power factor lagging is connected to a 120V(rms), 60Hz line. (a) Sketch and label the power triangle for the motor. (b) Find the rms current into the motor.

  Calculate hall voltage across the wire

An Aluminum wire with a square cross section 2mm on a side is carrying a current of 1.5amps. Aluminum has a resistivity of 2.69*10^-6 ohm-cm and an atomic volume of 10cc/mol. Assuming aluminum has three free electrons per atom

  What is the temperture when the output voltage

An intergrated circuit temperature probe is rated at 0-10 volts dc over a 0-175 degrees Celsius range. What is the temperture when the output voltage is 3.65 volts dc

  Which method for developing the mine should be used

A second method of development will recover only 50% of the ore deposit , but it will cost only $15 per ton of material removed.Subsequent processing of the removed ore recovers 300 pounds of metal from each ton of processed ore and cost $40 per ..

  Synchronization primitive in multiprocessor systems

Describe why interrupts are not appropriate for implementing synchronization primitive in multiprocessor systems.

  What is the rotor pole shift in electrical degrees

a) If the excitation voltage E0 is equal to the terminla voltage ( 4kV ), what is the maximum real power which the motor can deliver without losing synchronism  b) What is the rotor pole shift in electrical degrees, corresponding to the nominal loa..

  Need to use multisim and proteus

Need to use multisim and proteus and have build the circuit diagram on multisim and proteus, also have the program written, all u need to do its simulate it and take the necessary results.

  Use partial equilibrium anaalysis to predict the impact

what would be the advantage, if any, of using a general equilibrium analysis to answer this question? Illustrate diagrammatically.

  Discuss the sequence of actions that occur in the operation

Discuss the sequence of actions that occur in the operation of an automatic washing machine. Indicate which actions are time-driven and which actions are event-driven.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd