Which compressor should he buy and why

Assignment Help Civil Engineering
Reference no: EM13545646

A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the surface. When he goes to the dive shop to purchase an appropriate compressor he finds that there are three compressors that will deliver the air he needs but they are rated for 75, 125, and 200 psig. The compressors with the higher pressure ratings have higher costs. Which compressor should he buy and why?

Reference no: EM13545646

Questions Cloud

What is the elevation of point n : A leveling rod is held vertically on another point N. When a sight is taken on the rod, the telescope is inclined so that the horizontal cross line of the transit intersects the rod at a reading of 4.9 ft.
What was the difference in elevation between the two points : A rod was held on point B and the telescope is inclined so that the horizontal cross line of the transit intersects the rod at the 5.2 ft mark.If the reading on the vertical limb of the transit was +25° 19’, what was the difference in elevation betwe..
What is the diameter of the ball : A child at a park finds a ball floating in a freshwater pond (temperature 30 degree C). The child swims to the ball and, with an incredible amount of dexterity, balances himself on the ball
Explain how this change in fluid will affect the rate : A centrifugal pump is used to pump Vodka (S.G. 0.8) at a rate of 20 gallons per minute to the top of a 30 foot tall tank. The owner wants to use the same pump to pump orange juice (S.G. 1.1). Explain how this change in fluid will affect:
Which compressor should he buy and why : A diver is planning to salvage a Spanish galleon located in 200 feet of water. He plans to use a diving suit that will be supplied with air from a hose (assume this to be amply sized) connected to a compressor that he will locate in his boat on the s..
When the pump operates the measured power draw is equivalent : A pump for a wastewater treatment plant has a motor with a nameplate rating of 20 HP. When the pump operates the measured power draw is equivalent to 15 HP. The pump operates 80% of the time.
At what ocean level h will the gate first open : When using an automatic level and rod to conduct differential leveling for construction grade control of a concrete wall, the first necessary step following set up of the level is to:
The only section remaining to be installed is a segment : A town is installing a new 10” main to carry drinking water. The only section remaining to be installed is a segment through the middle of town. However, the excavators discover an archaeological site. The town decides to split the main into two sect..
Determine the cop of the heat pump and rate : Refrigerant 134a enters the condenser of a residential heat pump at 800 kPa and 35 degrees celcius at a rate of 0.018 kg/s and leaves at 800 kPa as a saturated liquid. If the compressor consumes 1.2 kW of power, determine a) the COP of the heat pump ..

Reviews

Write a Review

Civil Engineering Questions & Answers

  How much would the temperature in the garage increase

A garage (24 ft x 24 ft x 10 ft) is illuminated by (6) 60 watt incandescent bulbs. It is estimated that 90% of the energy to an incandescent bulb is dissipated as heat. If the bulbs are left on for 3 hours, how much would the temperature in the ga..

  What ph is required to precipitate all

Determine rqd impeller diameter, Qactual, h_p-actual, E, BHP required for...., NPSH_R, max elevation at which the pump can be installed.

  Determine the magnitude of the maximum shear stress

A torque of T = 3.00 kN-m will be applied to the hollow thin-walled aluminum alloy section. If the section has a uniform thickness of 4 mm, determine the magnitude of the maximum shear stress developed in the section.

  Enforcement team investigating possible dumping of arsenic

Suppose you are a member of an EPA enforcement team investigating the possible dumping of arsenic into Arbor Lake. You take water samples from the middle of the lake and find that the concentration is 90.0 ppb.

  Two streams discharge into a pipe as shown flows are

two streams discharge into a pipe as shown flows are incompressible. the volume flow rate of streams into the pipe is

  Determine how fast will the sleeve slide down the rod

when the sleeve and the rod are immersed in a pool of oil with dynamic viscosity of 0.095 kg/m.s, the effective weight of the sleeve is 4.5N. how fast will the sleeve slide down the rod

  Determine the asd reference and adjusted design values for

Determine the ASD reference and adjusted design values for the following members and loading conditions. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional buckling. Bending Occurs about the strong axis.

  Determine the radius of influence of the pumping

A well with a radius of 0.5 m pumps at a constant rate of 1240 m3/day. After the cone of depression has achieved equilibrium, the piezometric heads at two observation wells 40 and 95 m from the pumping well are measured as 78.9 and 83.4 above sea ..

  Find what is the op amp output voltage with a digital input

The reference current for the DAC0808 is 2.0 mA. With the DAC output connected to the inverting input of an op amp with a feedback resistor of 5.0 kohms, what is the op amp output voltage with a digital input of 0x80

  Determine what is the speed at touchdown

if the aircraft is encountering a steady side wind of speed vw=10 mi/hr , at what angle (a) should the pilot direct the aircraft so that the absolute velocity is parallel to the runway

  Find percentage of air voids and voids in mineral aggregates

Find the percentage of Air voids and voids in the mineral aggregate if the asphalt absorption is .5%, and the specific gravities of the aggregate and binder are 2.660 and 1.020 respectively. The unit weight of the mixture is 2.39 Mg/m^3

  Concrete dam retaining water

A concrete dam retaining water has a specific weight of concrete of 23.5kn/m3, what is the factor of safety against sliding & overturning and pressure intensity on the base if coefficient of friction is 0.45

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd