Which alloy and in what condition whould you choose

Assignment Help Civil Engineering
Reference no: EM13560456

1.If you were asked to manufacture aluminum points for automobile engines which alloy and in what condition whould you choose ND WHY?

2.For a concrete column that is part of a braced frame, if the column is square, tied, 18 inches per side, 16 feet long, classify the column as slender or non slender. Assume that at one end of the column a clockwise moment of 100 k-ft is present, and that at the other end of the column a counter-clockwise moment of 25 k-ft is present. you may assume that k= 1.

Reference no: EM13560456

Questions Cloud

Determine the flow rate in the pipeline and the head loss : Contract loss coefficient = Kc = 0.34 , d1 = 2 in , d2 = in d3 = 1 in , and Rm = 6ft , gauage fluid = 52lbf/ft^3 neglect friction but consider an expansion loss coefficient of k' = o.5
Calculate the steady state hcho concentration : These concentrations were measured when the trailers were 2 years old and the emission rate had significantly decreased by that time. New material rates as high as 290 mg/hr have been reported. Calculate the steady state HCHO concentration (ug/m3) re..
How efficient is the pump : A fireboat pump draws seawater (density=1.95 slugs/ft^3) from a 6 inch diamter submergred pipe that reaches 6 feet under the free surface and discharges 120 ft/s through a 2 inch diamter nozzle 10 feet above the free surface
Find the rate of biological growth : Two identical complete-mix activated sludge units are connected in series; one-half of the sludge recycle flow rate, QR, is recycled to the primary effluent pipeline which handles a flow rate Q, and the other half is recycled to the effluent line fro..
Which alloy and in what condition whould you choose : For a concrete column that is part of a braced frame, if the column is square, tied, 18 inches per side, 16 feet long, classify the column as slender or non slender
For a concrete column that is part of a braced frame : For a concrete column that is part of a braced frame, if the column is square, tied, 18 inches per side, 16 feet long, classify the column as slender or non slender. Assume that at one end of the column a clockwise moment of 100 k-ft is present
Which cross section option will provide the highest flow : Two channel cross sections are proposed. Assume slope, cross sectional area, and surface type are constant for each channel. Which cross section option will provide the highest flow rate? Show calculations.
What is the major head loss in a coarse concrete pipe with : What is the major head loss in a coarse concrete pipe with a diamter of 1ft that is 100 ft long. Water flows at a rate of 20 ft^3/s (viscosity of water = 2.344x10^-5 lbfs/ft^2, density of water = 1.94 slugs/ft^3) 1inch = 25.4mm
What is the major head loss in a coarse concrete pipe with : What is the major head loss in a coarse concrete pipe with a diamter of 1ft that is 100 ft long. Water flows at a rate of 20 ft^3/s (viscosity of water = 2.344x10^-5 lbfs/ft^2, density of water = 1.94 slugs/ft^3) 1inch = 25.4mm

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine how would distance be accomplished specifically

A sailboat capsizes a large distance from shore. What might be done to 1) right the boat and 2) prevent this from occurring again. How would this be accomplished specifically

  Determine the volume of direct surface runoff

Using the phi index calculated in part c, determine the volume of direct surface runoff (acre-ft) that would result from the following: hour: 1,2,3,4 ; intensity (in/hr): 0.40,0.05,0.30,0.20. phi index found to be 0.038 in/hr

  Concept of strengthening mechanisms

Describe in your own words the three strengthening mechanisms i.e., grain size reduction, solid solution strengthening, and strain hardening. Be sure to explain how dislocations are involved in each of the strengthening techniques.

  Determine will h increase or decrease and by how much

an air space above a long tube is pressurized to 50 kPa vacuum. water (20 degrees C) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25kPa vacuum, will h increase or decrease and by how much

  Estimate the hourly production and unit cost of rock

Estimate the hourly production and unit cost of rock excavation by drilling and basting. The rock is limestone having a seismic velocity of 6000 ft/s. Trial blasting indicates that 3" holes drilled in 12 ft.

  Determine the volume of irrigation water needed in ac-ft

A certain crop has a consumptive use requirement of 1.2 ac-ft of water per acre of crop land. The crop is planted on 780 acres of land. Precipitation falling during the growing season is 3.2 inches. The remainder of the 1.2 ac-ft /ac

  Determine the amount of garbage produced in the city

A city with 28,000 percent population is planning solid waste program. Population growth in the city is estimated to be 2.2% annually and the planning will designed for 30 years, The dumping area is located 20km away from the city.

  Determine the maximum change in length

Tensile tests of structural steel indicate that it fails when the axial tensile strain is 1800mu. Determine the maximum change in length that a 0:25-in diameter structural steel rod in tension can withstand before failure if it is 24 in in length

  The horizontal distance between the point

The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line

  Find reynolds number for the motion of baseball through air

(a) Find the Reynolds number for the motion of this baseball through air. (b) Determine the drag force on the baseball under these conditions in N.

  Determine the rise in water level within the drainage layer

A rectangular landfill in the New England area is 175 m in width, and sloped at the uniform angle of 75 degrees. Its cover system includes a drainage layer constructed of clean, medium sand (Ks = 10^-2 cm/s).

  What are the total delay and the average delay per vehicle

Assuming D/D/1 queuing, when does the initial queue clear and what are the total delay, the average delay per vehicle, longest queue length (in vehicles), and the wait time of 100th vehicle to arrive (assumin first-in-first-out)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd