When the pressure in the tank reaches the valve is closed

Assignment Help Civil Engineering

Reference no: EM13542305

Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3. When the pressure in the tank reaches 100 kPa, the valve is closed. The temperature in the tank when the valve is closed is reported to be 150 C. Determine whther this process is possible (Assume T0=25 C).

Reference no: EM13542305

Questions Cloud

Water heater that consists of an insulated pipe : It's proposed to have a water heater that consists of an insulated pipe of 5-cm diameter and an electric resistor inside. Cold water at 20oC enters the heating section steadily at a rate of 30L/min

The water temperature can be assumed to be 60 degrees : A gunite concrete trapezoidal channel with 1:2 side slopes, as ilustrated below, conveys 60 m3/s on a slope of 0.0005. Compute the depth of flow.

Will the quantity of coarse aggregate increase decrease : A concrete mix with a 3-inch slump, w/c ratio of .50, and sand with a finesse modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate per cubic yard. To adjust the mix so as to increase the compressive strenght

Describe how edge dislocations move under an applied : In the context of JCT 2005, to what extent can a subcontractor negligently set fire to an existing building with impunity?

When the pressure in the tank reaches the valve is closed : Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3.

Apply corrections for temperature pull and sag to determine : What is the water content and liquidity index of the fines in compacted mass?A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long.

Calculate the linear density of atoms in these directions : For FCC diamond cubic structures, give the lattice coordinates for the atoms found in the [100], [110], [111] direction? and Calculate the linear density of atoms in these directions for Ge.

Determine the correct horizontal distance considering : A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m

Draw the influence line for the shear at point b : Draw the influence line for the shear at point B. Plot numerical values every 5 ft. Assume the support at A is a roller and C is fixed. EI is constant.

User Account

All Pages