When the heat transfer of 200 kw occurs from the turbine to

Assignment Help Mechanical Engineering

Reference no: EM13624686

A steam turbine operates at steady state. Steam enters the turbine at 2.0 MPa and 350 °C with a specific enthalpy of 3137.0 kJ/kg and velocity of 30 m/s. The steam leaves the turbine at 0.1 MPa with a specific enthalpy of 2675.5 kJ/kg and a velocity of 80 m/s. The inlet is 5m higher than the exit.

(a) Determine the power developed by the turbine if the turbine is well-insulated and mass flow rate of steam at inlet is 1.5 kg/s.

(b) When the heat transfer of 200 kW occurs from the turbine to the surroundings, determine the mass flow rate of steam in order to generate the same power from the turbine.

Reference no: EM13624686

Questions Cloud

The tie rod ab and a pipe strut ac are used to support a : the tie rod ab and a pipe strut ac are used to support a 100-kn load as shown in the figure. both members are made of

A current of 135 a in an inductor l results in a stored : a current of 1.35 a in an inductor l results in a stored energy of 0.135 j. the current is then changed to 6.48 a in

The picture below shows a system where superheated vapor : the picture below shows a system where superheated vapor enters a container at a flow rate of 90 kgs at 250c. the vapor

A coach uses a new technique in training middle distance : a coach uses a new technique in training middle distance runners. the times for 8 different athletes to run 800 meters

When the heat transfer of 200 kw occurs from the turbine to : a steam turbine operates at steady state. steam enters the turbine at 2.0 mpa and 350 degc with a specific enthalpy of

You look directly at a point on the water that is a : a silver coin lies on the bottom of a clear lake 5.5 m deep. the coin is 4 cm in diameter. the index of refraction of

Determine the critical load on an air cylinder rod if the : determine the critical load on an air cylinder rod if the rod has a maximum extension of 0.5 m. the 25-mm-dia rod is

The mass is released from rest with the spring initially : consider a spring-mass oscillator. the mass is 3 kg the pulley is frictionless and its mass and the mass of the string

A frictionless piston-cylinder device contains 16 lbm of : a frictionless piston-cylinder device contains 16 lbm of superheated water vapor at 40psia and 600 degrees fahrenheit.

User Account

All Pages