Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
If the mean and variance of discrete random uniform random variable X, are E(X) and V(X) respectively, what would the mean and variance of cX be in terms of E(X) and V(X) if c is a constant?
A simple four-leg intersection needs a 2-phase fixed-time signal. The critical flows in the N-S and E-w directions are 600 and 400 veh/hr, respectively, with a 0.95 peak-hour factor.
A tank with a 3m diameter has an 8 cm orifice at the bottom. The tank is currently filled with water to a height of 2.5m above the orifice. If the orifice is opened, how long will it take until the height is 1 m.
A stack (T=550*F and P=750mm Hg) was sampled using EPA Method 5. The total gas volume that flowed through the dry gas meter was 2.785 cubic meters (at T=60*F and P=800mm Hg). The mass of particles collected was 1.50g.
A flowrate of 3.5 ft^3/s is to be maintained in a horizontal aluminum pipe ( E = 5 * 10 ^-6 ft). The inlet and outlet pressures are 65 psi and 30 psi, respectively, and the pipe length is 500ft. Determine the diameter of the pipe.
If the systems will reduce insurance claims by $100,000 two years from now, how much should the company be willing to spend now, it is uses an interest rat of 12% per year
The program should use both the maximum shearing-strength criterion and the maximum-distortion-energy criterion. It should also print the values of the principal stresses and, if the material does not yield, calculate the factor of safety.
Two materials (wrought iron, ks = 0.046 mm, and galvanized iron, ks = 0.15 mm) are being considered for a new pipeline. The expected discharge is 0.15 m3/s. Both the head loss and cost are sought for.
A PVC pipe with a diameter of 30 inches will carry a flow of 20 cfs. the bottom slope is 0.005 and the roughness coefficient is 0.015. determine the normal depth, critical depth, velocity and the froude number.
over the range of cylindrical parts manufactured on a computer-controlled lathe, the standard deviation of the diameters is 0.002 millimeter/ (a) what does Chebyshe's theorem tell us about the probability
The testing machin that covers the right range of load is to be chosen. it is expected to load the material up to a strains of 3%. if th material must remain elastic over that range, what would be the maximum load
calculate the ratio of the area to volume for unit cube,a unit sphare inscribed inside the cube,and as right cylinder inscribed inside the cube.
A left-turn movement has a maximum arrival rate of 200 veh/h. The saturation flow of this movement is 1400 veh/h. For this approach, the yellow time is 4 seconds, all red time is 2 seconds and total lost time is 3 seconds.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd