What would the height of a water tower with a gallon tank

Assignment Help Civil Engineering
Reference no: EM13312428

what would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft?

Reference no: EM13312428

Questions Cloud

Determine what is the angle theta required for equilibrium : Rope segment BC creates an angle of phi2 = 74.0^\circ with the floor and rope segment CD creates an angle theta with the horizontal. If both ropes BCA and CD can support a maximum tensile force T3 = 130 lb,
Find the maximum compression of the spring : A 3.40 kg block starts from rest and slides down a frictionless incline, dropping a vertical distance of 2.60 m, Find the maximum compression of the spring
Determine the equilibrium concentrations of a, b : Consider the following reaction: A(g)= B(g)+C(g) Find the equilibrium concentrations of A, B, and C for each of the following different values of Kc. Assume that the initial concentration of A in each case is 1.0 M
Provide guidance for federal government procurement : Describe the major regulations that regulate and provide guidance for federal government procurement.
What would the height of a water tower with a gallon tank : what would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft
Find the mole fraction and mass fraction of each component : The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to the moles (n) of the component ( n = kA) in the sample injected in the GC.
Explain what is the equilibrium concentration of h3o+ : Consider the following reaction: HC2H3O2 (aq) + H2O (l) = H3O+ (aq) + C2H3O2- (aq) Kc=1.8*10^-5 at 25C If a solution initially contains 0.260M HC2H3O2, what is the equilibrium concentration of H3O+ at 25C
Determine factored uniform load per foot which beam supports : Structural steel beams are to be placed at 7ft 6in on center under a reinforced concrete floor slab. If they are to support a service dead load D=64 psf of floor area and a service live load L=100 psf of floor area
Explain what molarity of aqueous calcium chloride solution : What molarity of aqueous calcium chloride solution can be expected to show the same conductivity as 0.0050 M aluminum sulfate at 12,500 units.

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the width of the second floor

A cross section of a cottage, 20 ft wide, is an isosceles triangle. If the slope of a side is 1.75 and there is a second floor 8 ft above the ground floor, what is the width of the second floor?

  Determine what percent of the hocl is dissociated

A solution of HOCl is prepared in water by adding 15 mg HOCl to a volumetric flask, and adding water to the 1.0 L mark. The final pH is measured to be 7.0. What are the concentrations of HOCl and OCl

  Presedimentation-uspended solids concentration of raw revers

Presedimentation can reduce the suspended solids concentration of raw river water from 500 mg/L to 200 mg/L. How many pounds of dry solids does this represent per million gallons?

  Temporary change on the highway

Determine the minimum distance from the diversion that a road sign should be located informing drivers of the temporary change on the highway. The letter height on the road sign is 5 inches.

  Determine the deflection in degree for horizontal wind speed

Determine the deflection in degrees for horizontal wind speed of 10m/s and what is the magnitude of the force required at the bottom of the sign to prevent the sign from deflecting

  Determine appropriate dimensions of the finished water

Determine appropriate dimensions of the finished water clearwells to achieve adequate disinfection using chlorine. Flow Rate Q = 30 million gallons paer day.

  Design the pins so that the ledge can support doug

Design the pins so that the ledge can support Doug and Jeremy and eight others on each side of the building. Assume each person weighs 200 lbs.Pin properties: Ultimate shear strength = 100 lb/in^2

  Calculate the water or cement ratio of the cement paste

Calculate the water/cement ratio of the cement paste in which all the cement will hydrate to leave no capillary pores. (density of cement: 3.1 g/cm3) ?

  Calculate maximum compressive and maximum tensile stresses

Consider a wide flange steel beam of size W10x60 subjected to a negative bending moment of 24 kip ft. Calculate the maximum compressive and maximum tensile stresses and indicate where the stress will be tensile and where compressive.

  Determine the critical load of a round wooden dowel

Determine the critical load of a round wooden dowel that is 0.9m long and has a diameter of (a) 10mm (b) 15mm. Use E=12GPa

  At what speed will a stationary observer on the earth

A jet aircraft is flying in a standard atmosphere at an altitude of 4,000 m at 900 km/hr. The frontal intake area of the jet engine is 0.80 m2. The engine exhaust area is 0.56 m2. The temperature of the exhaust gas is 120°C.

  Evaluate the acceleration along and normal to the path

The velocity along a pathline is given by V (m/s) = s^2 x t^(1/2) where s is in meters and t is in seconds. The radius of curvature is 0.5 m. Evaluate the acceleration along and normal to the path at s = 2m and t = 0.5 seconds.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd