What would the height of a water tower with a 500 gallon

Reference no: EM13559286

1.A prismatic bar is loaded by an axial force P. Show that P must be directed through centroids of cross section if axial stress SIGMA is not to vary over a cross section.

2.A fluid that occupies a volume of 32 L weighs 280 N at a location where the gravitational acceleration is 9.8 m/s2. Determine the mass of this fluid and its density.

3.The density of an ideal gas decreases by 10% when compressed isothermally from 10 atm to 11 atm. Determine the percent decrease in density of the gas if it compressed isothermailly from 1000 atm to 1001 atm.

4.What would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft?

Reference no: EM13559286

Questions Cloud

Determine the intensities w1 and w2 of the distributed load : Which two-dimensional point lattice corresponds to the cyrstalline ceramic illustrated in Figure 1.8(a) of the text book. Provide a sketch of the unit cell

Determine the factored uniformly distributed loads per foot : A structural steel beam supports a roof that weighs 20 psf. An analysis of the loads has the following: S=12 psf, L_r=18 psf and W=38 psf (upwards) or 16 psf (downwards). If the beams are spaced 6ft 0 in apart

Find the mole fraction and mass fraction of each component : A gaseous mixture of carbon monoxide, carbon dioxide, methane and nitrogen gas is analyzed with a gas chromatograph (GC). The output takes the form of a series of peaks where each peak corresponds to a component and a peak area (A) is proportional to..

Calculate the minimum length of this curve : If the clearance is not adequate in this type of case what modification to L would be required to increase the clearance? Discuss possible ramifications of making this modification. (Do not need to do any calculations in part c).

What would the height of a water tower with a 500 gallon : What would the height of a water tower with a 500 gallon tank have to be, to bring water ( by gravity ) from sealevel over a distance of 2.5miles with an elevation of 300ft?

What is the magnitude of the force required at the bottom of : The 1.5m2 pub sign hanging outside The Drunken Engineer, weighs 200N and is hinged along its top edge. Determine the deflection in degrees for horizontal wind speed of 10m/s and what is the magnitude of the force required at the bottom of the sign to..

Find through what distance does the piston drop : Suppose a monatomic ideal gas is contained within a verticalcylinder that is fitted with a movable piston. find Through what distance does the piston drop

Determine the inside heat transfer coefficient : The specific heat capacity Cp of the process fluid is not known at the mean bulk fluid temperature but is a linear function of temperature, and must be calculated using the following information, Cp at 300K is 1.98 kJ/kgK, and Cp at 400K is 2.65 kJ/k..

Compute the sample mean variance and standard deviation and : For the grouped data acting as of each of the data point in an interval was actually located at the midppoint of that interval, compute the sample mean,variance and standard deviation and compare with the results above.

User Account

All Pages