What would be purpose of connecting a parallel-tuned circuit

Assignment Help Other Engineering
Reference no: EM131017532

Questions 1 to 20: Select the best answer to each question. Note that a question and its answers may be split across a page break, so be sure that you have seen the entire question and all the answers before choosing an answer.

1. A line filter would be used to remove
A. pulsating DC voltages from a rectifier.
B. line frequencies from an alternator.
C. low frequencies from an AC line signal.
D. high-frequency noise spikes from an AC line signal.

2. Which of the following components has the same amount of opposition to current flow at all frequencies?
A. Transformer
B. Inductor
C. Resistor
D. Capacitor

3. Which of the following is a disadvantage of the waveguide as compared to a transmission line?
A. Waveguides are more difficult to install.
B. Waveguides leak signal into the air.
C. Waveguides can't be used at any of the higher frequencies.
D. Waveguides can only be used in low-power applications.

4. In the formula that's used to calculate the constant-M for a high-pass filter, fe stands for the
A. counter impedance.
B. cutoff frequency.
C. filter capacitance.
D. resonant frequency.

5. For any filter, the more selective the filter is, the closer its shape factor will be to a value of
A. 1.
B. 0.
C. 100.
D. 2.

6. For a particular filter, the multiplication of the series impedance and the shunt impedance produces a fixed value over the range of frequencies for which the circuit is designed. This type of filter is the
A. M-derived filter.
B. line filter.
C. constant-K filter.
D. crystal filter.

7. Which of the following is a disadvantage of using a resistor in place of an inductor in a power-supply filter?
A. A resistor weighs much more than an inductor.
B. The life of the capacitors will be shorter.
C. A resistor will cost much more than an inductor.
D. The output DC voltage will be lower.

8. A filter that always contains at least one tuned LC circuit that's either in series with or across the signal line is the
A. high-pass filter.
B. low-pass filter.
C. M-derived filter.
D. constant-K filter.

9. Which of the following components passes low frequencies but offers high reactance to high frequencies?
A. Capacitor
B. Resistor
C. Switch
D. Inductor

10. To remove pulsations from a power-supply output, you could use a
A. band-reject filter.
B. low-pass filter.
C. high-pass filter.
D. band-pass filter.

11. Richard says "a band-pass filter can be made with a series-tuned LC-circuit." Pam says "a band-pass filter can be made with a parallel-tuned LC-circuit." Who is correct?
A. Both Richard and Pam are correct
B. Neither Richard or Pam is correct
C. Pam is correct
D. Richard is correct

12. You have a tuned circuit with a resonant frequency of 3.7 MHz and a quality factor (Q) of 250. The bandwidth of this circuit is approximately
A. 148 kHz.

B. 14.8 kHz.
C. 1,480 kHz.
D. 1.48 kHz.

13. For a band-pass filter, the range of frequencies between the points on a characteristic curve that are about 70 percent of the maximum value is called the
A. resonance.
B. Q factor.
C. bandwidth.
D. cutoff frequency.

14. Which of the following is a correct variation of the Joule's law equation?

A. P = V/I
B. P = V2/R
C. P = I x R2
D. P = I2/V

15. Which of the following conditions would be necessary in order for you to use an r-f transformer as a very sharply tuned band-pass device?
A. The primary and secondary windings should be overcoupled.
B. A capacitor should be connected between the primary and secondary windings.
C. A series-tuned LC circuit must be connected across the secondary winding.
D. The primary and secondary windings must be shielded from each other.

16. Another name for the capacitive-input power-supply filter is the
A. T filter.
B. r-f filter.
C. pi filter.
D. wave trap filter.

17. Which of the following components offers less opposition to high frequencies than to low frequencies?
A. Capacitors
B. Inductors
C. Resistors
D. Diodes

18. What would be the purpose of connecting a parallel-tuned circuit into an antenna circuit?
A. To increase the signal strength
B. To increase the antenna impedance
C. To remove an unwanted frequency
D. To remove undesired spikes on the signal

19. In a characteristic curve for an overcoupled r-f filter, the steep sides of the curve are called the
A. windings
B. skirts.
C. brackets.
D. bandwidths.

20. What is the conjugate impedance for 5 ∠ -20o?
A. 200 ∠ 0°
B. -5 ∠ 20°
C. 25 ∠ 20°
D. 5 ∠ 20°

Reference no: EM131017532

Questions Cloud

Exploring likenesses and differences between texts : Previewing: Learning about a text before really reading it. Comparing and contrasting related readings: Exploring likenesses and differences between texts to understand them better
How have the authors formulated the problem : Do the authors refer to the work of others that they do not agree with? What are the key concepts or the main factors or variables discussed?
Describe how these standards apply to financial audits : Discuss the additional requirements that are placed on auditors from this Act, and the actions of the PCAOB.
Briefly explain the function of a heat pump : Define the following four terms, with reference to your description of the power/wind-speed curve: cut-in wind speed, rated wind speed, shut-down wind speed, and rated power. Briefly explain the function of a heat pump.
What would be purpose of connecting a parallel-tuned circuit : Which of the following is a disadvantage of using a resistor in place of an inductor in a power-supply filter - What would be the purpose of connecting a parallel-tuned circuit into an antenna circuit?
Has quantitative easing proven to be an appropriate : Has Quantitative Easing (QE) proven to be an appropriate and effective response to the Great Recession in the United Kingdom and the United States? Compare and contrast QE in both countries from 2008 until the present time?
Why is the capital-budgeting process so important : What is the payback period on each project? If Caledonia imposes a 3-year maximum acceptable payback period, which of these projects should be accepted?
How might the pricing policies for sony ebooks change : The following table shows book sales in the U.S. during 2004. With what you know about the impact of the Internet, what are some of the key differences you would expect to see if you had the equivalent table in the year 1994? If possible, suppo..
Capital stock is sold at an amount greater than stated value : Capital stock is sold at an amount greater than stated value.

Reviews

Write a Review

Other Engineering Questions & Answers

  To examine the relationship between fermenter design and

to examine the relationship between fermenter design and operating conditions oxygen transfer capability and microbial

  What is the friction factor of the tunnel

determine the resistance of the tunnel. If 70 m3 /s of air is passed along this tunnel what would be the pressure drop along the tunnel and what is the friction factor of the tunnel?

  The chi-square distribution is a discrete distribution

In using chi-square for testing the independence of variables, the table of observed frequencies is constructed under the assumption that the null hypothesis is true.

  Sketches the process of longshore drift

Describe and explain with sketches the process of longshore drift. Describe what happens to a beach when a wall is built that obstructs the longshore drift.

  Evaporative crystallizer operating

An aqueous solution of potassium hydroxide is fed at a rate of 875 kg/h to an evaporative crystallizer operating at 10°C, producing crystals of KOH·2H2O. A 5 g aliquot of the feed solution is titrated to neutrality with 22.4 mL of 0.85 molar H2SO4..

  Accelerating power pss model - simulink model

There is block diagram called PSS2A, Ineed this block diagram at simulink model which will give graphs like below. so I also need those graphs. So basically i need PSS2A simulink model which will produce those graphs shown below.

  Does each solution stop all the negative effects

How long has this situation been going on? Why did the problems begin when they did? Am I able to solve the problem at its root cause or am I only able to manage the impact of the problem? Is this a temporary or permanent problem? How has the company..

  Short notes on bionic-robotic limbs

Problem (Issues that the public is facing that this technology will have a profound effect on)

  Characteristic of the transition and transversion mutations

Construct a dot-plot for the pair of sequences using the matrix methods and determine the best global alignment via trace-back using NW algorithm - Perform SW-algorithm based comparison between the two given sequences and elucidate the common regions..

  Input impedance on transmission

An antenna having an input impedance on transmission of 70+j30 ohms is used on reception by connecting directly to a 50 ohms transmission line which is perfectly matched to a pure resistance load.

  Develop three scenario overviews relating global population

Develop three scenario overviews relating to global population growth -- one disastrous, one hopeful, and one complete wildcard (the reading will explain about wildcards).

  Specify predecessor-successor linkages between two tasks

What is another way to specify predecessor-successor linkages between two tasks? Describe AND provide a screen shot of the steps

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd