Reference no: EM132952491

The following questions may be answered verbally with your assessor or you may write down your answers. Please discuss this with your assessor before you commence. Short Answers are required which is approximately 4 typed lines = 50 words, or 5 lines of handwritten text.

Your assessor will take down dot points as a minimum if you choose to answer them verbally.

Answer the following questions either verbally with your assessor or in writing.

1. In what documentation might you identify and obtain the OHS procedures for a given work area at would need to be understood through the established routines and procedures?

2. Identify and discuss the hierarchy of established risk control measures that will need to be implemented and followed for the risks identified in preparation for the work.

3. What will you need to do about safety hazards that have not previously been identified?

4. Identify at least 1 of the types of documentation or deemed to comply standard on which the installation is based that will need to be reviewed and understood for the task.

5. Who is the appropriate person from which to seek advice about the effective coordination of work with others?

6. When should tools, equipment and testing devices that are needed to verify compliance be checked for correct operation and safety?

7. List at least 6 of the requirements that preparatory work may need to be checked to ensure compliance with.

8. What OHS risk control measures and procedures can be followed to reduce the risks associated with manual handling while carrying out the work?

9. What is required for the determining the need to test and measure live and for the conducting of the testing?

10. Briefly discuss the requirements for the checking of circuits, machines and/or plant as being isolated.

11. What does wiring need to be checked for?

12. How can the calculation of the expected fault loop impedance for a given circuit arrangement can be determined?

13. It is essential that the range of switchgear and control gear that is required for the installation is checked for rating and functional requirements and verified against what requirements?

14. Briefly outline the correct sizing of earthing conductors.

15. What will it be necessary to check for when checking the marking on switchboard for clarity and accuracy?

16. Mandatory tests will need to be conducted to ensure what information?

17. What testing will need to be conducted on fault-loop impedance and residual current devices?

18. Outline the safe manual handling safety and assessment tasks that should be completed throughout conducting manual handling tasks during work completion.

19. What types of clearing tasks may be completed top clean and make the worksite safe in accordance with established procedures? List at least 4.

20. What information will need to be obtained and reported about any non-compliance defects?

21. What is it necessary to ensure when making recommendations for rectifying defects according to established procedures?

22. When completing mandatory documentation in accordance with established procedures, the results of what 4 types of tests will need to be taken on industry approved documentation?

23. What information will the above documentation require for AS 3000 requirements?