What will the phosphorus concentration of the river

Assignment Help Civil Engineering
Reference no: EM131376089

Question -

The village of Pongelton is in the valley of the River Pong. The mean flow of the river is 3.0 m3. The population of Pongelton is 6,000. The daily average water consumption is 250 litre/head day. Water utilisation (i.e. the water spent for watering gardens, watering animals, etc) is 20% Sewers are built in the village and the construction of a sewage treatment works is planned.

The local government also wishes to construct a small recreational reservoir downstream of the site of the planned effluent discharge. The Environment Agency requires an assurance that the aquatic environment of the planned reservoir will not be impaired by the discharge of the final effluent from the sewage treatment works. Thus, the Environment Agency will require the sewage treatment works to be designed for phosphorus removal, in order to avoid eutrophication downstream of the discharge. To achieve this, the concentration of phosphoru in the inflow to the planned reservoir must be less than 40 mg/m3. The average phosphorus concentration of household sewage is 10 mg/I and the phosphorus concentration of the unpolluted river, upstream of Pongelton is 10 mg/m3.

You are the designer and must address the following issues:

Clarifications for questions:

1544_Figure.png

Data as drawing:

G=250L/hd /days

Q1=3.0m^3/s

C1=10mg/m^3^3

Q2=mg/L

C3<40mg/m^3

DO=Dsat-Dc=10.8-1.84=8.mg/L

Solve the following issues:

1. If no treatment facility is provided, what will the phosphorus concentration of the river be downstream of the sewage discharge?

2. Does this value meet the EA's quality requirements?

3. If not, in percentage terms, what degree of treatment should be provided for phosphorus removal. Express your answer in percentage terms (i.e. percentage of phosphorus to be removed).

Reference no: EM131376089

Questions Cloud

What is the after tax cost of debt : Suppose a company will issue new 20-year debt with a par value of $1,000 and a coupon rate of 9 percent, paid annually. The tax rate is 40 percent. If the flotation cost is 2 percent of the issue proceeds, what is the after-tax cost of debt?
Prepare a research study on single parenthood : Prepare a research study on Single Parenthood
Calculate the cost of each capital component : Calculate the cost of each capital component (that is, the after-tax cost of debt), the cost of preferred stock (including flotation costs), and the cost of equity with the DCF method and the CAPM method.
What is the purpose of the orifice : What is the purpose of the orifice? Why is it not a good idea to drill out orifices in the field?
What will the phosphorus concentration of the river : If no treatment facility is provided, what will the phosphorus concentration of the river be downstream of the sewage discharge? Does this value meet the EA's quality requirements
Government budget surplus affect the us economy : How does a government budget surplus affect the U.S. economy? Identify two periods in recent history in which the United States has run budget surpluses. What were the reasons for the surpluses during those time periods?
How to use the corporate valuation model : Explain how to use the corporate valuation model to find the price per share of common equity.- Explain how it is possible for sales growth to decrease the value of a profitable company.
Discuss the evolution of the heat exchanger : Explain why furnace efficiencies jump from 80 percent to 90 percent.
Market supply in a perfectly competitive market : 1."Suppose the market supply in a Perfectly Competitive market reflects a constant marginal cost. Assuming the market demand is the usual downward-sloping variety (and linear), what value (i.e., a specific number) is the total Producer Surplus in ..

Reviews

len1376089

1/30/2017 2:23:22 AM

This is my assignment in civil engineering and I am provide you with good clarification with question. If you want lecture notes, I can provide you with these lecture notes that will help you to solve my assignment.

Write a Review

Civil Engineering Questions & Answers

  Find the final air pressure and the work output of the heat

A rigid tank contains 4 kg air at 300?C, 4 MPa that acts as the hot energy reservoir for a heat engine with its cold side at 20?C, shown in Fig. P6.99. Heat transfer to the heat engine cools the air down in a reversible process to a final 20?C and..

  Make reasonable assumptions as to the soil properties

Soil borings made at a site near Chicago indicate that the top 6m is lose and miscellaneous fill, with the groundwater table at 3m below the ground surface. Below this is a fairly soft blue-gray silty clay with an average water content of 30%. The bo..

  Prepare a technical report involving all technical aspects

Prepare a technical report involving all technical aspects to illustrate the capabilities and usage. So, Students are requested to prepare a technical report

  Determine the total dead load-per foot of length

Three-ply asphalt felt and gravel roof over 2in of insulation board is supported by 18in deep precast reinforced concrete beams with 3ft wide flanges. If insulation weights 3lb/ft 2 and the asphalt roofing weights 5.5lb/ft2, determine the total dea..

  F-m ration for conventional activated sludge plant

A 4000-m 3 /day conventional activated sludge plant has an influent with a BOD5 of 190 mg/L and SS of 225 mg/L. What population would this plant serve?

  Is it right for johnson to omit reference to the data

Thirty six year old Johnson was in his last semester of his graduate program in Civil engineering. Father of two small children, he was anxious to get his degree so that he could spend more time with his family.

  Determine the acceleration of the vehicle immediately

A vehicle is traveling on a curved section of a road of radius 2500 feet at a speed of 60 mi/h. The motorist suddenly applies their brakes, causing the automobile to slow down at a constant rate. After 8 seconds the speed has been reduced to 45 mi..

  Determine the approximate dimensions of each carbon

A two-bed carbon adsorption system is to be designed to handle 8000 acfm of air containing 700 ppm of hexane. Laboratory studies indicate that carbon can adsorb 8lb hexane per 100 lb carbon under the conditions at which the system will be operated.

  Determine how long will generator run on a tankful of fuel

A Bonda portable generator is powering a small travelling fridge (120V) in your RV and consumes 125 watts. The efficiency of the generator's gas motor is 23% and the electrical portion (power head) is more efficient at 91%.

  Determine the uniform flow depth in a trapezoidal channel

Determine the uniform flow depth in a trapezoidal channel with a bottom width of 8 ft and side slopes of 1 vertical to 2 horizontal. The discharge is 100 ft3/s. Manning roughness factor is 0.015 and the channel bottom slope is 0.004.

  Determine tthe allowable soil bearing pressure with respect

Three soil borings were performed at the site of a structure and the SPT blow counts at each depth are shown below. (Do not make any corrections to the blow counts.

  How to select lightest w-section for column a in the frame

Use A992 steel (Fy=50ksi). In the plane perpendicular to the frame, the system is braced with supports at the top and bottom. Use stiffness reduction factor τ to determine effective length k

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd