What will be the velocity and flow rate for the model

Assignment Help Mechanical Engineering

Reference no: EM13720685

A dam spillway is tested with a 1/30th scale model, matching the Froude number. The flow over the dam has an average velocity of 0.6 m/s and a volume flow rate of 0.08 m^3/s.

a. What will be the velocity and flow rate for the model?

b. If a force is measured on the model as 1.5 N, what is the corresponding force on the real dam?

Reference no: EM13720685

Questions Cloud

Standard refrigerator and a window air conditioner problem : A kitchen contains a standard refrigerator and a window air conditioner. The refrigerator operates at steady state using 200 W of electric power and a COP of 3. If the kitchen is well insulated:

Calculate the compressor outlet temperature : If the isentropic efficiency of the compressor is 72% and the pressure ratio is 2.2:1, for an inlet pressure and temperature of 1 bar and 25oC, calculate the compressor outlet temperature, the compressor outlet density and the power required to drive..

Describe a physically-plausible situation : Describe a physically-plausible situation where the Reynolds number is (a) 1 (b) 10,000 (c) 1,000,000. For flow in tubes/pipes/ducts, use Red For flow over/along long/blunt objects, use Rel.

For water at room temperature : For flow of viscous fluids through a 5 cm diameter pipe, for what flow rate in m3/h would we expect transition to turbulence?

What will be the velocity and flow rate for the model : A dam spillway is tested with a 1/30th scale model, matching the Froude number. The flow over the dam has an average velocity of 0.6 m/s and a volume flow rate of 0.08 m^3/s.

What pressure should the air in the wind tunnel : A model of an airplane is to be tested at 20°C in a wind tunnel. The model is built to 1/12th scale. In order to match both the Mach number and the Reynolds number of the plane, the wind tunnel is pressurized. To what pressure (in atm) should the air..

Determine the overall heat transfer coefficient U : A deep freezer for hazardous chemicals is to be maintained at -20oF to insure a safe environment for the chemicals. The freezer is in a room that is kept at 60oF, and the inner and outer walls of the freezer are made of 26-gauge (0.0184-in) steel.

Determine the K-values from a DePriester chart : A stream containing 57 mol % n-Octane and the remainder Ethylene is to be separated by flash distillation. The molar flow rate of the stream is 823 mol/hr. The temperature and pressure of the stream entering the flash drum are 105°C and 325 kPa. De..

Drum pressure and drum temperature : A feed that is 50 mol% methane, 10 mol% n-butane, 15 mol% n-pentane, and 25 mol% n-hexane is flash distilled. F=150 kmol/h. Drum pressure =250 kPa, drum temperature =10 degrees celcius. use the depriester charts. find V/F, xi, yi, V, L.

User Account

All Pages