What will be the steady-state concentration of selenium

Assignment Help Civil Engineering

Reference no: EM13544552

Plateau Creek carries 5.0 m^3/s of water with a selenium (SE) concentration of 0.0015 mg/L. a farmer starts withdrawing 1.0 m^3/ of the creek water to irrigate the land. During irrigation, the water picks up selenium from the salts of the soil. One-half of the irrigation water is lost to the ground and plants, and the other half is returned to Plateau Creek. The irrigation run-off to the creek contain 1.00 mg/L of selenium. Selenium is a conservative, nonreactive substance, and the stream does not pick up more selenium from any other source.

a) If the farmer irrigates continuously, what will be the steady-state concentration of selenium in the stream downstream from the farm (after the irrigation run-off returns to the stream)?

Reference no: EM13544552

Questions Cloud

Find the steady state concentration if the air in the box : Consider the air over a city to be a box 100km on a side that reaches up to an altitude of 1.0 km. The air is blowing into the box along one of its sides with a speed of 4 m/s

Determine the force p that must be applied to the cylinder : The brass tube AB (E=105 GPa) has a cross-sectional area of 140 mm^2 and is fitted with a plug at A. The tube is attached at B to a rigid plate that is itself attached at C to the bottom of an aluminum cylinder

Determine the required do concentration in the treatment : Given the following information, determine the required DO concentration in the treatment plant effluent discharge in order to ensure that at no point downstream the DO in the river drops below 4 mg/L:

Determine the required diameter of the thread : A nylon thread is to be subjected to a 10-N tension. Knowing that E=3.2 GPa, that the maximum allowable normal stress is 40 MPA, and that the length of the thread must not increase by more than 1%, determine the required diameter of the thread.

What will be the steady-state concentration of selenium : If the farmer irrigates continuously, what will be the steady-state concentration of selenium in the stream downstream from the farm (after the irrigation run-off returns to the stream)?

Find the axial load and the total change in each cross : A flat bar of cross section 20mm by 70mm elongates 4.0mm in a length of 2.0m as a result of axial load. If the elastic modulus is 199x106 kN/m2 and Poisson's ratio is 0.25 for the material, find the axial load and the total change in each cross secti..

Determine magnitude and direction of resultant force : Calculate the area of the triangle - exponential functions using logarithms - Determine the magnitude and direction of the resultant force.

Determine the normal stresses induced in the steel and in : The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F).

Notch fracture toughness show your supportin calculations : A Charpy V Notch test was conducted for an ASTM A572 Grade 50 bridge steel. the average values of the test results at four different test temperatires were found to be

User Account

All Pages