What was the rovers weight when it was at sea level on earth

Assignment Help Civil Engineering
Reference no: EM13564837

1.Consider a rectangular wastewater treatment cell having a length of 100ft, width of 20ft and depth of 20ft. If the flow into the cell is 50ft^3/min, calculate the residence time of the treatment cell.

2.When the Mars Exploration Rover was fully assembled, its mass was 180 kg. The acceleration due to gravity at the surface of Mars is 3.68 m/s2. a) What was the rover’s weight when it was at sea level on Earth? b) What is the rover’s weight on the surface of Mars?

3.Determine the range from the SV to the REC in GPS; using codes C/A and P and also waves (L1 and L2). How does two of the below from the list have an effect on the codes and waves? 1. Determination of time 2.atmospheric errors 3.correlation of signal at REC 4.what is actually measured at the REC 5.AODC effects on the GPS signal 6.Accuracy

Reference no: EM13564837

Questions Cloud

What average thickness must the engineer build to meet these : An engineer uses a standard technique for measuring the thickness of a clay landfill liner that has a typical standard deviation of 0.7 in. The project specifications require the liner thickness to be 36 inches or more, at least 95 percent of the tim..
Determine the size of the beam with the least cross-section : A simple beam of Douglas-Fir Larch, select grade, has a span of 18 ft with two concentrated loads of 3 kips each placed at the third points of the span. Neglecting its own weight, determine the size of the beam with the least cross-sectiona; area bas..
Calculate the depth of flow upstream of the bridge assuming : A tensile test was performed on a metal specimen having a circular cross section with a diameter of 0.50 inch. The gage length is 2 inches. For a load of 13.5 kips, the elongation was 4.66 x 10-3 inches. If the load is assumed to be within the linear..
Find which dam would need to be constructed more strongly : If a large lake is held back by a dam that is equallylong and equally deep compared to another body of water, but is anarrow river, which dam would need to be constructed more strongly
What was the rovers weight when it was at sea level on earth : When the Mars Exploration Rover was fully assembled, its mass was 180 kg. The acceleration due to gravity at the surface of Mars is 3.68 m/s2. a) What was the rover’s weight when it was at sea level on Earth? b) What is the rover’s weight on the surf..
What is the velocity of the police car : While standing at a crosswalk, you hear a frequency of540 Hz from an approaching police car. What is the velocity of the police car
What is thefrequency of the sound heard by the crew : An aircraft carrier has a speed of 13.0 m/s relative to thewater. What is thefrequency of the sound heard by the crew on the ship
Determine the stack-gas so2 concentration in units of micro : The sulfur dioxide (SO2) stack-gas concentration from fossi-fuel combustion is 2 ppmv. Determine the stack-gas SO2 concentration in units of micro grams/m^3. Assume 0C and 1 atm pressure
Find what is the minimum angle the ladder can make : A 3.0-m-long ladder leans against a frictionless wall. What is the minimum angle the ladder can make with the floor without slipping

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the concentration of bod in the river-wastewater mix

he City of Leeds (England) discharges about 1.4 m3/sec to the Aire River. Without the wastewater discharge, the river flow rate would be 12.7 m3/sec. Given that BOD(river) = 3.0 mg/L and BOD(wastewater) = 30.0 mg/L

  How much energy in horsepower is lost by the water while

A pipeline 1200 ft long and 8 in. in diameter has at its inlet point 75ft of available hydraulic energy with respect to the reference level. The velocity in the pipe is 5 fps: the pressure at its end is 12psi.

  Predict the temperature required in an isothermal plug flow

Using the method of lee et al. predict the temperature required in an isothermal plug flow incinerator to reduce the xylene level in a waste gas from 1000 ppm to 10ppm. Assume a residence time of 0.7 sec.

  Determine the difference between the pressure is acting

Shaquille O Neal, who is listed as 7`1" tall is out of the NBA Playoffs and so has time to visit is pool. If he stands vertically in the water, completely submerged, determine the difference between the pressure is acting at his head and at his toes,..

  What is the maximum that each of these 2 equal loads can be

A 100 mm diameter log is subjected to two equal loads equally spaced along its 450 mm length at 150mm intervals. The beam has an allowable flexural stress of 9 MPa and a much lower allowable shear stress parallel to the grain of 850 kPa

  What is the hydraulic radius of a rectangular channel

What is the Hydraulic Radius of a rectangular channel that has a bottom width of 5 feet and a flow depth is 3.5 feet. Assume the bed slope is 1.5%, and the Manning's roughness coefficient is 0.013.

  Determine what ph results when mole of nah are added

The temperature = 25°C; assume that u = 10^-2 after the addition. Compare the value obtained when ionic strength effects are taken into account with that calculated when it is neglected.

  Determine the mean effective pressure of an ideal otto cycle

Determine the mean effective pressure of an ideal Otto cycle that uses air as the working fluid. At the beginning of compression the pressure is 14 psi and the temperature if 60°F.

  What is the pressure drop per unit length along the tube

It is known that the velocity distribution for steady, laminar flowin circular tubes (either horizontal od vertical) isparabolic. Consider a 10 -mm- diameter horizontal tubethrough with ethyl alcohol is flowing with a steady mean velocity.15 m/s.

  Find the probability that student smokes but does not drinks

Suppose that in a senior college class of 500 students it is found that 210 smoke, 258 drink alcoholic beverages, 216 eat between meals, 122 smoke and drink alcoholic beverages, 83 eat between meals and drink alcoholic beverages

  Calculate the final length and final diameter of specuman

A cylinder with a 6.0 in., diameter 12.0 in. height is put under a compresive load of 150 kips. The modulus of elasticity for this specimen is 8000 ksi and Poisson's ratio is 0.35. calculate the final length and the final diameter of this specuman..

  Shafts in a speed-reducer unit

The two shafts in a speed-reducer unit are subjected to couples of magnitude M1 = 18 N · m and M2 = 7.5 N · m, respectively.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd