What was his minimum vertical velocity as he left the ground

Assignment Help Physics
Reference no: EM13674163

A player for a college football team blocked a field goal attempt by jumping and knocking the ball away in front of the crossbar at a point 11 feet above the field. If Owens was 6 ft. 3 in. tall, and could reach 1 ft., 11in. above his head, what was his minimum vertical velocity as he left the ground?

Reference no: EM13674163

Questions Cloud

Two events occur in inertial system k at the same time : Two events occur in an inertial system K at the same time, however 4km apart. What is the time difference gauged in a system K’ moving parallel to these two events when the distance separation of the events is gauged to be 5km in K’?
How deep is the ocean beneath the ship : The speed of sound in water is 1498 m/s. A sonar signal is sent straight down from a ship at a point just below the water surface, and 1.80 s later the reflected signal is detected. How deep is the ocean beneath the ship?
The wave speed in a guitar string : The wave speed in a guitar string is 265 m/s. The length of the string is 63 cm. You pluck the center of the string with pulling it up and letting go. Pulses move in both directions and are reflected off the ends of the string.
What is the electric field at the aircraft : An airplane is flying during a thundercloud at a height of 1800 m. If a charge concentration of +60.0 C is above the plane at a height of 3000 m within the cloud and a charge concentration of -40.0 C is at height 1300 m, what is the electric field at..
What was his minimum vertical velocity as he left the ground : A player for a college football team blocked a field goal attempt by jumping and knocking the ball away in front of the crossbar at a point 11 feet above the field. If Owens was 6 ft. 3 in. tall, and could reach 1 ft., 11in. above his head, what was ..
Will cause the ball to land within three feet of the hole : A golfer stands 30 ft away and 3 ft below a hole on a flat raised green. If the sand wedge the golfer utilizes to hit the ball gives the ball an initial angle of 50 degrees, decide the range of velocities v0 that will cause the ball to land within th..
What constant angular velocity is required : The radial distance from the center of a centrifuge to a sample is 6m. You would like to subject the sample to a normal acceleration of 100g's. What speed of rotation in RPM is needed? If you want the centrifuge to reach this rotational speed from re..
To what temperature should the rivet be cooled : Bridge builders often use rivets that are larger than the rivet hole to make the joint tighter. The rivet is cooled before it is put into the hole. A builder drills a whole 1.2230 cm in diameter for a steel rivet 1.2250 cm in diameter.
Hot air balloons contain a fixed volume of gas : Hot air balloons contain a fixed volume of gas. When the gas is heated, it expands, and pushes some gas out at the lower open end. As a result, the mass of the gas in the balloon is reduced.

Reviews

Write a Review

Physics Questions & Answers

  Find the magnitude of the resulting magnetic field

A sphere of radius R is uniformly charged to a total charge of Q. It is made to spin about an axis that passes through its center with an angular speed ω. Find the magnitude of the resulting magnetic field at the center of the sphere.

  Find the equivalent resistance

A resistor is in the shape of a cube, with each side of resistance  R . Find the equivalent resistance between any two of its adjacent corners.

  What is the electric field at the location

Question: Field and force with three charges? What is the electric field at the location of Q1, due to  Q 2 ?

  What is the maximum displacement of the bridge deck

What is the maximum displacement of the bridge deck?

  What is the magnitude of the current in the wire

What is the magnitude of the current in the wire as a function of time?

  Blackbody

Questions on blackbody, Infra-Red Detectors & Optic Lens and Digital Image.

  Gravity conveyor

Illustrate the cause of the components accelerating from rest down the conveyor.

  Calculate the dc voltage

Calculate the dc voltage applied to the circuit.

  Quadrupole moments in the shell model

Quadrupole moments in the shell model

  Determine the tension in each string

Determine the tension in each string

  Introductory mechanics: dynamics

Calculate the smallest coefficient of static friction necessary for mass A to remain stationary.

  Evaluate maximum altitude

Evaluate maximum altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd