What value of vdc will allow the maximum possible value

Assignment Help Electrical Engineering
Reference no: EM13288678

Consider the BJT voltage follower below. Suppose tahtits input consists of a dc source value VDC=5V in series with a1kHz, 4.0 V p-p sinusoidal signal Vs and a resistorRs=10kOhm.
a) What is the lowest value of Vcc for which the BJT willalways remain in the active region? Sketch Vl versus time for a Vcc slightly lower than this limit. Which BJT region(saturationor cuttoff) limits the output voltage swing?
b)For the case VCC=15V, what value of VDC will allow themaximum possible value of Vs if the BJT is to remain in its active region?

Reference no: EM13288678

Questions Cloud

Explain what is the final mass upon mixing of hcl : what is the final mass upon mixing 8.54 mL of HCl and 8.54 mL of NaOH, both solutions have an initial concentration of 2.00 M.
Discussion typical reasoning : Discussion Typical Reasoning
How much charge does each capacitor carry : Three identical capacitors are connected in parallel to a battery. If a total charge of Q flows from the battery, how much charge does each capacitor carry
How to calculate the absorbance at ph : A solution of a weak acid, HA, is prepared by dissolving 4.8 mmol of HA in 10.0 liters of a solution.The following values of absorbances were measured in a 1.0 cm cell in various buffers.
What value of vdc will allow the maximum possible value : What is the lowest value of Vcc for which the BJT will always remain in the active region. Sketch Vl versus time for a Vcc slightly lower than this limit. Which BJT region(saturationor cuttoff) limits the output voltage swing.
What gravitational force does earth exert on the satellite : A 600-kg geosynchronous satellite has an orbital radius of 6.6 Earth radii. What gravitational force does Earth exert on the satellite
Which is most likely to raise the unemployment rate : According to Keynesian economics, which of the following is most likely to raise the unemployment rate?
Explain hydrogen are produced by the unbalanced reaction : How many moles of hydrogen are produced by the unbalanced reaction below when 0.195 moles of magnesium and 0.102 moles of water are allowed to react? Mg (s) + H20 (l) > Mg(OH)2 (s) + H2 (g)
Describe the center-tapped secondary needed to obtain : A power utility pole has a transformer with 2400 turns in theprimary and 4.5kV coming from the power line. Describe the center-tapped secondary needed to obtain 240V(120V/120V) for a commercial customer.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd