What value of resistors are required for the voltage divider

Assignment Help Electrical Engineering

Reference no: EM13229573

A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference between the two resistors is a voltage divider connected to +5V and ground. What value of resistors are required for the voltage divider to allow the ATD to output 1 step/degree change?

Reference no: EM13229573

Questions Cloud

What is the value of the feedback resistor required : A temperature sensor covers a range of 0 to 70 degrees C with an output sensitivity of 2 mV/degree C. The sensor is input to an ADC with voltage range of 0 to 4V. What is the value of the feedback resistor required for an inverting amplifier circu..

Explain new procedure and measured by chromatography : Traces of toxic, man-made hexachlorohexanes in North Sea sediments were extracted by a known process and by a new procedure, and measured by chromatography.

Determine magnetic flux density using mean radius of toroid : Assume the coil around the toroid is one single coil and extends all the way around. A toroid is like a donut with a circular cross section. The following characteristics are given: Toroid material = sheet steel, N = 250 turns Inner Radius

State the percentage of an additive in gasoline was measured : The percentage of an additive in gasoline was measured six times with the following results: 0.14, 0.15, 0.16, 0.17, 0.20, 0.11%. Find the average and RSD and 90% confidence intervals for the percentage of the additive.

What value of resistors are required for the voltage divider : A HCS12 ATD is set to 8-bit unsigned mode. A temperature sensor measuring 0 to 100 degrees with an output of 25 mV/degree is attached to the input. The ATD low voltage reference is attached to ground and the high voltage reference

Describe target markets of each branded supermarket : Draw the layout of each store and if possible include photographs-make sure you indicate the brand on the diagram

Find a minimum two level circuit using and gate : Find a minimum two level circuit (corresponding to the sum of products expressions) using AND and one OR gate per function for each of the following sets of functions: f(a,b,c,d) =fm(1,3,5,8,9,10,13,14) g(a,b,c,d) =fm(4,5,6,7,10,13,14)

Explain the ratio of the number of atoms of the isotopes : The ratio of the number of atoms of the isotopes 69Ga and 71Ga in eight samples from different sources was measured in an effort to understand differences in reported values of the atomic mass of gallium

Determine change in resistance when the temperature rises : A platinum resistance coil has a resistance at O0 C of 100 . Determine the change in resistance that will occur when the temperature rises to 30°C if the temperature coefficient of resistance is 0.0039 K-1.

User Account

All Pages