What type of system would you classify an electric wire

Assignment Help Civil Engineering
Reference no: EM13555049

A system consists of a gas confined between a cylinder and piston such that work and heat may cross the boundary. What type of system is that? What type of system is a free body as used in mechanics or civil engineering? What type of system would you classify an electric wire with current passing through it?

Reference no: EM13555049

Questions Cloud

What is the steady-state concentration of radon : Consider a house into which radon is emitted through cracks in the basement. The total volume of the house is 650 m3 (assume that the volume is well mixed throughout).
What is the lowest frequency produced by the organ pipe : An organ pipe open at one end has a length of 60 cm. If the speed of sound in air is 340 m/s, what is the lowest frequency produced by the organ pipe
What is the longitudinal strain under this load : A 4 meter long steel plate with a rectangular cross section (10mm x 50mm) is resting on a frictionless surface under the sun. The plate temperature is measured to be at 40 degrees Celsius.
How large must be the tank volume : Neon gas at 50 degrees C in a vertical cylinder of diameter 150 mm has a 6 kg frictionless piston mounted. The outside pressure is 98kPa and the neon volume is 4000cm^3. Find the mass of neon.
What type of system would you classify an electric wire : A system consists of a gas confined between a cylinder and piston such that work and heat may cross the boundary. What type of system is that? What type of system is a free body as used in mechanics or civil engineering? What type of system would you..
Plot the ground level concentration of sulfur dioxide : With air pollution control equipment in place, plot the contours for a ground level concentration that is half and ¼ of the maximum value and indicate on your plot the location of the stack and the location of the point where the maximum ground level..
Calculate the atmospheric pressure head : A barometer filed with non-toxic glycerin is used to measure standard sea level atmospheric pressure. neglecting the effect vapor pressure and surface tension. calculate the atmospheric pressure head.
How many days will it take for 90 per- cent of the chemical : How long will it take for 99 percent of the chemical to be destroyed? (c) How long will it take for 99.9 percent of the chemical to be destroyed?
What is the length of shrinkage : A meter long steel plate with a rectangular cross section(10mm x 50mm) is resting on a frictionless surface under the sun.the plate temperature is measures to be at 40C.the plate is then moved into a cold room and is left to rest on a frictionless su..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Which the original 13 colonies were surveyed

Fixed GPS broadcast stations enable users to make differential measurements to other points whose positions are needed. In the US, there are two such networks two such networks of broadcast stations, name one (blank)

  Compute the speed of the sandbags just as it hits the ground

During a hot air balloon race one specific balloon, initially at rest, accelerate vertically upward at a constant rate of a=4.5 ft/s^2 when t0=42 s from the ground the surface, which is at an altitude above mean sea level of s0=3750 ft.

  Define base isolation technique has become the method

Base isolation technique has become the method of choice for structural design of buildings and bridges located in highly seismic areas in recent years.

  Determine will h increase or decrease and by how much

an air space above a long tube is pressurized to 50 kPa vacuum. water (20 degrees C) from a reservoir fills the tube to a height h. If the pressure in the air space is changed to 25kPa vacuum, will h increase or decrease and by how much

  Determine the rotational speed of the rollers

The distance from the center of the plate to the point of contact between the plate and the roller is 12 cm. The radius of the roller is 0.5 cm. Assuming no slip between the wheels and the plate, determine the rotational speed of the rollers.

  How much excess pore water pressure would need to develop

The vertical effective stress at a certain point in a loose sand is 1000lb/ft^2. If an earth quake were to occur, how much excess pore water pressure would need to develop at this point for liquefaction to occur

  Estimate the force on the chimney and the bending moment

A 10m height chimney has a 2.0m x 2.0m square cross section. The wind blows horizontally in a direction which is parallel to one of the diagonals of the cross section.

  Determine the force required with an angle of 20 degrees

A 10 kg block is being pulled down a slope with an angle of 20 degrees and has a velocity of .2 m/s. Determine the force required

  Determine the angular velocity of link bc at the instant

If rod slides along the horizontal slot with a velocity of 44 ft/s , determine the angular velocity of link BC at the instant

  Find probability that none of sampled items are defective

A sample of six items is drawn from this lot. Find: a) the probability that none of the sampled items are defective b) the probability that one or more of the sampled items is defective c) the probability that exactly one of the sampled items is d..

  What is the compressor power input in kw

A vapor-compression refrigeration system, using Refrigerant 134a as the working fluid, has evaporator and condenser pressure of 1.4 bar and 12 bar, respectively. The refrigerant passes through each heat exchanger with a negligible pressure drop

  Sketch and annotate the wedge described above

Sketch and annotate the wedge described above.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd