What turns ratio must be used to get maximum power transfer

Assignment Help Electrical Engineering
Reference no: EM13279461

If an amplifier has an internal resistance of 500O, what turns ratio must be used to get maximum power transfer to a load of 4O.

Reference no: EM13279461

Questions Cloud

Define dilute sodium hydroxide : Write the net ionic equation, A stream of chlorine gas is passed through a solution of cold, dilute sodium hydroxide.
What are the funds available to the parent mnc : 1. What are the funds available to the parent MNC if foreign taxes can be applied as a credit against the MNC's U.S. tax liability? 2. What are the funds available to the parent MNC if no tax credits are allowed?
Define what is the density of the heated air in the balloon : A small hot air balloon is filled with 1.02 x 10^6 L of air (d=1.20 g/L). As the air in the balloon is heated, it expands to 1.13 x 10^6 L. What is the density of the heated air in the balloon
High validity and predicts job success well : Which assessment system would be better to use? An assessment system that has high validity and predicts job success well but that is also very expensive and results in fairly high levels of adverse impact.
What turns ratio must be used to get maximum power transfer : If an amplifier has an internal resistance of 500O, what turns ratio must be used to get maximum power transfer to a load of 4O.
Explain gases that occur in the troposphere : Order these five gases that occur in the troposphere from most abundant to least abundant: Rn, CO2, CO, N2, Ar and O2.
Determine which branch has the largest current flow : A parallel circuit contains four branches with resistors values of 4.7k, 5.6k, 8.1k and 10k. Which branch has the largest current flow
Calculate the after-tax weighted average cost of capital : Given the following data for U&P Company: Debt (D) = $100 million; Equity (E) = $300 Million; rD = 6%; rE = 12% and TC = 30%. Calculate the after-tax weighted average cost of capital (WACC)
Write a linear program that minimizes cost : Write a linear program that minimizes cost. What is the optimal production cost and the total amounts of A31 and C42?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain what can be deduced about b and why

A 2-input NOR gate has inputs A and B. If the output of the gate remains LOW independent of the state of input A, what can be deduced about B

  Solve using gauss-seidel method perform four iterations

Solve Using Gauss-Seidel Method (Perform Four Iterations) Using the Gauss-Seidel method and the initial guess X1(0)=1, solve the following equation (x_1)^2 - 6x_1 + 2 = 0

  Determine the thermal equilibrium recombination

A semiconductor, in thermal equilibrium, has a hole concentration of p0 = 2x1016 cm-3. The minority carrier life time = 3x10-7 s. (Assume, ni = 1010 cm-3)

  Create a sequence detector that recognize the sequence

Create a sequence detector that recognizes the following sequence on input X with overlap: "1011101", and sets the output Y to 1 when the sequence has been detected. a) Provide the state diagram and truth table showing the previous state

  Evaluate required received power that achieves a bit error

Data at a rate of 2 Mbps is to be transmitted via a pass-band communication system whose carrier frequency is 500MHz. A binary antipodal system with roll-off factor of 0.2 is used for this communication. The AWGN single-sided power spectral densit..

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Find the output powers at the through ports

A 1 W power source is connected to the input of a directional coupler with C=20 dB, D=35 dB, and an insertion loss of 0.5 dB. Find the output powers (in dBm) at the through, coupled, and isolated ports. Assume all ports to be matched.

  What range of sampling frequency allows exact reconstruction

An analog signal contains frequencies up to 10kHz. (a) What range of sampling frequencies allows exact reconstruction of this signal from its samples. (b) Suppose that we sample this signal with a sampling frequency Fs = 8kHz.

  What is the range of no-load voltage vt as r adj

The magnetization graph taken at 1800 rpm of a 6 kW, 120 V, 50 A, 1800 rpm, dc generator is attached below. Field resistance is 20 ohms and armature resistance is .18 ohms. Find: As a seperately excited generator

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Determine which is the best sensor

The following specification s are given for fours different temperature sensors. If the application requires a temperature variation of -50°C to 120°C and the measured value is -20°C, select the best sensor.

  What price would you try to negotiate

Suppose you are the supplier and can produce 20 units now but cannot start production on the second 20 units for two months. What price would you try to negotiate for the last 20 units?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd