Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
When communicating with a geostationery satellite from earth,the distance between transmitter and receiver is approximately 35000km.assume that the friis law for free space loss is applicable and the stations have parabolic antennas with gains 60db and 20db at the 11ghz carrier frequency.1) draw the link budget between transmitted power ptx and received power prx2) if the satellite receiver requires a minimum received piwer of -120 dbm what transmit power is requires at te earth station antenna
A telecommunication system has a link bandwidth of 10 MHZ, signal propagation of 3.5 x 10^8 m/s, transmitting as 1500 frames per minute, with 15000 bits per frame, over a distance of 100 km. What is the bandwidth-delay product?
A mote draws an average of 200mA when "awake", 0.1mA when "sleeping", and 400mA (total) when "transmitting". Transmitting data takes 2ms, and sensor acquisition takes 1ms. If the maximum size battery available is 5000mAh
What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?
A phase modulation is used to transmit the signal s(t) = 10cos(20*pi*t) + 5sin(10*pi*t). kp = 3 rad/volts and fc = 20MHz a) What is the instantaneous frequency of the signal b) Write down the expression of the transmitted signal.
Draw up a flow chart for testing any four-terminal MOSFET with an ohmmeter which can be used to conclusively determine which lead is the gate, which lead is the body, whether the device is an n-channel or p-channel, and whether the device is a D-m..
A 60-Hz source supplies power to an industrial load through a transmission line of impedance (0.2+ j0.1) ohms. The load consumes 130 kW of power at line voltage VL= 440
Suppose we want to construct a parallel plate capacitor of C= 1[F] using square plates. (a)If the dielectric is air (Xr= 1), and the plates are separated by 1 cm, what dimensions will the plates have
Find steady-state error to the unit ramp input. If it is greater than 0.1, design a lag compensator that helps to achieve the steady-state error (to the unit ramp input) no more than 0.1. (Hint: Use Matlab to nd the dominant closed-loop poles.)
The following data were obtained or a 30-kva, 60 hz, 2400-240V transformer tested at 60hz. Voltage (V), Current(A), Power(W) O.C. Test 240V, 3.0 A, 230 W S.C. Tes..
A calibrated RTD with ALPHA = 0.0041/°C, R = 306.5 Ohms at 20°C, and PD = 30 mW/°C will be used to measure a critical reaction temperature. Temperature must be measured between 50° and 100°C with a resolution of at least 0.1°C.
Consider a permanent-magnet dc-motor with the following parameters: Ra=0.35Ohms, La=1.5mH, Ke=0.5V/(rad/s), Kt=0.5Nm/A, and Jm=0.02kgm^2. The rated torque is 4Nm. This motor is supplies by a switch-mode dc-dc converter
A WLAN uses the 1-Mbps IEEE 802.11 infrared standard and the 16-PPM modulation scheme. Compute the period of transmission (time between bits).
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd