What speed should the wind tunnel be run

Assignment Help Mechanical Engineering

Reference no: EM13701632

A 1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pressure of 20 atmospheres. The plane is expected to fly at a speed of 500 [km/hr]. (a) What speed should the wind tunnel be run? (b) If the drag measured on the model is 337.5 [N], what is the corresponding drag on the full size airplane? Recall that the viscosity is effectively independent upon pressure changes.

Reference no: EM13701632

Questions Cloud

Determine the total entropy change for this process : A 60-kg iron block and a 39-kg copper block, both initially at 76oC, are dropped into a large lake at 9oC. Thermal equilibrium is established after a while as a result of heat transfer between the blocks and the lake water. Determine the total entrop..

Determine the change of the entropy of the entire system : Ten grams of computer chips with a specific heat of 0.3 kJ/kg dot K are initially at 15 degrees C. These chips are cooled by placement in 5 grams of saturated liquid R134a at -38 degrees C.

Determine the angular velocity after : The 0.6-kg mass is supported by two arms of negligible mass. The angle ? of the arms can be varied by changing the force F acting on the slid- ing collar. When ? = 70?, the assembly is rotating freely about the vertical axis with the angular velocity..

Steam is the working fluid in a simple : Steam is the working fluid in a simple, ideal Rankine cycle. Saturated vapor enters the turbine at 8 MPa and saturated liquid exits the condenser at a pressure of 8 kPa. The net power output of the cycle is 100 MA.

What speed should the wind tunnel be run : A 1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pressure of 20 atmospheres. The plane is expected to fly at a speed of 500 [km/hr]. (a) What speed should the wind tunnel be run? (b) If the drag measure..

Liquid in a tube varies with tube diameter : The capillary rise, h, of a liquid in a tube varies with tube diameter, d, gravity, g, fluid density, roe , surface tension, Y, and the contact angle, B. (a) Find the dimensionless form of this statement. (b) If h = 3 [cm] in a given experiment, what..

Determine the heat added to the cycle per kilogram : A closed gas turbine unit uses neon as the working fluid. There are two stages of compression with inter cooling from 480kPa and 290K to a maximum pressure of 2.75MPa with an intermediate pressure of 1149kPa. The regenerator has an effectiveness of 6..

Consider the addition of an afterburner to turbojet engine : Air at 22 kPa, 220K and 250 m/s enters a turbojet engine in flight at an altitude of 10,000m. The diffusor slows the air down to a very low speed relative to its inlet. The pressure ratio across the compressor is 12. The turbine inlet temperature is ..

Steam enters a converging nozzle : Steam enters a converging nozzle at 800 kPa and 280 C with negligible velocity. If the expansion is isentropic, what is the minimum pressure that can be reached in such a nozzle and what is the cross-sectional area at the nozzle throat at this pressu..

User Account

All Pages