What register is used to keep track of the return point

Assignment Help Electrical Engineering
Reference no: EM13251035

What happens to the program counter (PC) when a subroutine is called? What register is used to keep track of the return point? What happens to the register that keeps track of the return point if a subroutine calls another subroutine?

Reference no: EM13251035

Questions Cloud

Determine the emf of the cell : A solar cell generates a potential difference of 0.320 V when a 445.0 ? resistor is connected across it and a potential difference of 0.504 V when a 945.0 ? resistor is substituted. What is the emf of the cell
Describe differences between bureaucratic and decentralized : Describe the differences between bureaucratic and decentralized control. What are the advantages and disadvantages of each?
Find speed of the electron when it strikes the second plate : A uniform electric field exists in the region between two oppositely charged plane parallel plates. An electron is released from rest at the surface of the negatively charged plate and strikes the surface of the opposite plate
Describe how a budget is created in most organizations : Describe how a budget is created in most organizations. How does a budget help a manager with financial control?
What register is used to keep track of the return point : What happens to the program counter (PC) when a subroutine is called. What register is used to keep track of the return point. What happens to the register that keeps track of the return point if a subroutine calls another subroutine
What is the initial kinetic energy of the car : A 1000kg car moving 40m/s skids to a stop. During the skid, the only force is the frictional force between the tires and the road, What is the initial kinetic energy of the car
Explain what are the concentrations of barium : A solution is prepared by mixing 70.0 mL of 0.010 M BaCl2 and 175 mL of 0.080 M K2SO4. What are the concentrations of barium and sulfate ions in this solution? Assume only SO42- ions (no HSO4? ) are present.
What is resistance of resistor that should be connected : A (3V, 300mA) flashlight bulb is to be used as the dial light in a 120V radio. What is the resistance of the resistor that should be connected in series with the flashlight bulb to limit the current
What is the resulting ucl value for the line : From the samples you determine the fraction defective is 0.05 and the standard deviation is 0.01. If the desired confidence level is 99.7 percent, what is the resulting UCL value for the line?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine what is the max height obtained

A ball is shot into the air at 30 degress above the horizontal. It's initial Velocity is 5m/s and lands at the same height that it is launched from. How far does it travel horizontally

  Determine the range of load resistances over the circuit

a) Determine the range of load resistances over which the circuit gives a constant Vout if Rs = 1500 kilo ohms and Vs = 150V. Assume the diode breakdown voltage is 100V and the maximum rated current is 100 mA.

  Find the percentage of aliasing level at cutoff frequency

Given a DSP system in which a sampling rate of 8000 Hertz is used and the antialiasing filter is a second order Butterworth low pass filter with a cutoff frequency of 3.2 KHz determine a. The percentage of aliasing level at cutoff frequency

  What is the vswr on the line is measured

The unknown input impedance of a horn antenna operated at a frequency of 300MHz is measured using a slotted transmission line and a Smith Chart. When the antenna is connected to the slotted line, the VSWR on the line is measured to be 4

  What value of the average signal power is required

"Power Outage" refers to that the receive signal power falls below a certain threshold. Consider for a RF signal in a Rayleigh fading channel with average receive signal power 22 = - 80dBm. What will be the power outage probability of this channel..

  Determine what is the terminal voltage of the cell

An automobile battery has an open-circuit voltage of 13.6 V and a total internal resistance of 0.012 ohms. What is the terminal voltage of the cell when it is delivering 250 A to the starter motor

  What will the secondary voltage be

If a transformer has a turns ratio of 1:5 and a primary voltage of 20 V AC, what will the secondary voltage be?

  Find impulse response of equation using z-transform

For the difference equation below, find the impulse response by first solving without any transforms. Assume sequence is zero-valued for n

  How long a 1 inch square bar of copper have resistance

Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C

  Compute the average price increase for gold

Gold cost about $100 an ounce in 1971. In 2007, the cost of an ounce of gold is hovering around $800. compute the average price increase for gold.

  Define the voltage and current in the laplace domain

The voltage and current in the Laplace domain for a certain system is given by V (s) = 1/12 1/s^2 +3, I(s) = s/s^2+3. Is this system best described as resistive, capacitive, or inductive?

  How much is the spring compressed in stopping the ore car

An ore car of mass 35000 kg starts from rest and rolls downhill on tracks from a mine. At the end of the tracks, 26 m lower vertically, is a horizontally situated spring with constant 3 × 105 N/m.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd