What power is dissipated by an electric range

Assignment Help Electrical Engineering
Reference no: EM132066964

(a) What power is dissipated by an electric range element that has a resistance of 65 Ω when drawing a current of Ipeak = 5A?

(b) What are the peak and RMS supply voltages (Vpeak and Vrms )?

(c) Use the attached graph paper to sketch two cycles of the current waveform, assuming this is a 50Hz source

Reference no: EM132066964

Questions Cloud

What are the firm ROE and ROIC : The firm finances with only debt and common equity, so it has no preferred stock. What are the firm’s ROE and ROIC?
Calculate the price of share of company common stock : Stockholders' equity as reported on the firm’s balance sheet = $6.5 billion, Calculate the price of a share of the company's common stock.
Analyze military spending and growth through the lens : Analyze military spending and growth through the lens of the so-called republican dilemma. Do you think this supposed trade-off between security and freedom.
What is its debt-to-capital ratio : The firm's total capital is $140 million and it finances with only debt and common equity. What is its debt-to-capital ratio?
What power is dissipated by an electric range : (a) What power is dissipated by an electric range element that has a resistance of 65 O when drawing a current of Ipeak = 5A?
What is its accounts receivable balance : Baxley Brothers has a DSO of 46 days, and its annual sales are $5,840,000. What is its accounts receivable balance? Assume that it uses a 365-day year.
Determine the maximum bit rate possible : The dispersion parameter of the fibre is D = 80 ps/(km-nm). The LED optical source has a spectral width of 51 nm. Determine the maximum bit rate possible.
Described by an impulse response : A system is described by an impulse response h(t) = delta(t - 2) - delta(t + 4)
What is the slew rate : What is the common mode gain? The figure shows the output voltage of an OP AMP in response to a step input. What is the slew rate?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Physical and chemical equations used in process models

Give the schematic table that has the Physical and chemical equations used in process models used in measurement systems.

  Find the corresponding thevenin voltage and norton current

When a 100-k load is connected to a signal source, the output voltage is 30 mV. If a 10- k resistor is used to load the same signal source, the output voltage is observed to be 10 mV. Find the corresponding Thevenin voltage, Norton current

  Find valve of starting resistor limiting armature current

A 500V shunt dc motor has a nominal armature current of 40A, and operates at 1200 rpm. if the armature resistance is 0.25 (ohm), calculate The valve of a starting resistor limiting the initial armature current to 60A

  Find and draw the thévenin equivalent of the circuit

Find and draw the Thévenin equivalent of the circuit shown. The load resistor is RL.- Find and draw the Norton equivalent of the same circuit.

  Find the thévenin impedance with respect to the terminals

a) Find the amplitude and phase of the Thévenin voltage with respect to the terminals a, b. b) Find the Thévenin impedance with respect to the terminals a, b. c) Draw the Thévenin source physical equivalent circuit.

  Is the spectral line at the bit rate stronger or weaker

Rewrite the MATLAB simulation of Computer Example 4.3 for the case of an absolute-value type of nonlinearity. Is the spectral line at the bit rate stronger or weaker than for the square-law type of nonlinearity?

  How much power is this in milliwatts

If the output power of a preamplifier is 20 dBm, how much power is this in milliwatts?

  Why is this digest not secure

The cryptographic hash function adds the current value of the digest to the value of the current character (between 0 and 25). Addition is in modulo 26. What is the value of the digest if the message is "HELLO"? Why is this digest not secure?

  Show the contents of the token bucket and the buffer

The sender is allowed to send five packets per second, but, since it does not use this right fully during the first four seconds, it can send more in the next three seconds. Show the contents of the token bucket and the buffer for each second to p..

  Detect two separate bit flips in a code word

Devise an example using an 8-bit code word to show that even parity and odd parity cannot be used to detect two separate bit flips in a code word.

  Write a vhdl test bench for the uart

If suitable hardware is available, write a simpler test bench to allow a loop-back test with TxD externally connected to RxD. Synthesize the test bench along with the UART, download to the target device, and verify correct operation of the hardwar..

  Where is this charge density distributed

Calculate the charge density on the inner and outer conductors. Where is this charge density distributed?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd