What percentage of the total load is carried by the shaft

Assignment Help Civil Engineering

Reference no: EM13548160

What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft? use a safety factor of 2.5 .for problem 7 you are not given enough information to do an effective stress analysis (i.e. what is the friction angle, where is the water table located?), so only do a total stress analysis for the problem.

Reference no: EM13548160

Questions Cloud

A fan is to be selected to ventilate a bathroom whose : A fan is to be selected to ventilate a bathroom whose dimensions are 2 m x 3 m x 3 m. The air velocity is not to exceed 8 m/s to minimize vibration and noise.

Determine the acceleration of the rod : A rectangle commercial building must be laid out 200.00 ft wide and 300.00 ft long. if the steel tape used is 100.02 ft long under standard conditions, what distances would be laid out?.

Will the surveyor have to measure to locate the new station : Station 3 + 54.67 must be marked in the field. if the steel tape to be used is only 99.98 under standard conditions and if the temperature is 87 degree farenheit at the time of the measurement, how far away from the existing station mark at 0 + 79.23..

There will be 3 hurricane-free years within the next 5 years : A 10-year hurricane is subjected to occur at a given region. Determine the probability that:

What percentage of the total load is carried by the shaft : What would be the load carrying capacity of a 250 mm-diameter and 15 m-long timber pile driven into soft clay with an unconfined compressive strength of 40 Kpa? What percentage of the total load is carried by the shaft?

Estimate its load carrying capacity assuming a safety factor : A 12 m-long and 800 mm-diameter drilled pier is constructed in a clayey soil with a1.5 m-diameter bell at the base. The top 7 m of the clay has an average Cu of 40 Kpa and the clay underneath has a Cu of 90 Kpa

For the problem compare two cases : A 250 mm- diameter and 16 m-long timber pile is driven into a sandy soil where ?= 18 kN/m3 and ?' = 34 degree. Estimate the maximum load allowed on the pile with a safety factor of 2.5

What is the probability that among 10 automobile accidents : Assuming that 50% of the automobile accidents are due to a speed violation. a) What is the probability that among 10 automobile accidents at least 6 will be due mainly to a speed violation?

Compute the volume flow rate required to produce : Compute the volume flow rate required to produce a Reynolds number of 3.60 x 10 ^4. then, if the pipe is clean steel, compute several points of the velocity profile and plot the data.

User Account

All Pages