What percent removal efficiency may be expected under

Assignment Help Civil Engineering

Reference no: EM13563768

A cyclone separator is being used to remove particulates from a gas stream. The current removal efficiency is 96% for an air flow rate through the separator equal to 18 m3/s. Due to a process change, the air flow rate is expected to increase to 22 m3/s.

What percent removal efficiency may be expected under the new condition?

Removal efficiency (R, in %) has been expressed as an empirical correlation in terms of the ratio (r) of particle diameter (d) to cut diameter (dC), defined as the diameter of particles for which removal efficiency is 50%.

R = 1.5 x - 17.92 x2 + 72.37 x3 - 6

The cut diameter is usually assumed to be inversely proportional to the square root of the air flow rate, i.e., dC = k Q-1/2.

Reference no: EM13563768

Questions Cloud

Determine the net power output of this engine : Consider a Carnot heat-engine cycle executed in a steady-flow system using steam as the working fluid. The cycle has a thermal efficiency of 35%, and steam changes from saturated vapor at 300 C during the heat addition process. If the mass flow rate ..

Find the linear velocity of the lifter with respect to point : A circular cam is in contact with a rectangular lifter and used to intermittently operate a piece of equipment at the end of a lifter arm. The lifter is constrained to move only in the vertical direction. The cam has a radius of r = 7.2in and is rota..

Determine the horizontal components of the forces necessary : A 6 foot diameter pipleine carries water at a temperature at 60F at a steady flow rate of 60 cubic feet per second. The pipeline makes a 90 degree horizontal bend.

Estimate a value of msw generation in the year 2025 : The United States Environmental Protection Agency (EPA) has published the following data for municipal solid waste generation (in millions of tons).

What percent removal efficiency may be expected under : A cyclone separator is being used to remove particulates from a gas stream. The current removal efficiency is 96% for an air flow rate through the separator equal to 18 m3/s. Due to a process change, the air flow rate is expected to increase to 22 m3..

Calculate a value of temperature that could be used : A correlation for particulate removal efficiency in an electrostatic precipitator (n) as a function of gas velocity (u) may be written in the form: n = 1 - e^-k / u.

Determine the proportional limit stress the modulus : At the proportional limit, a 32-mm-thick by 87-mm-wide bar elongates 10.2 mm under an axial load of 532 kN. The bar is 2.4 m long. Poisson%u2019s ratio, , for the material is 0.27.

Can one collector be temporarily taken out of service by : Dust is removed from the airstream of a municipal incinerator by four dust collectors operating in parallel, each handling 1/4 of the total airflow of 200 m3/min. The airstream contains 10 g/m3

Design the flexural reinforcement for this member : A rectangular concrete beam of width b = 24 inches is limited by architectual considerations to a maximum total depth of h = 16 inches. it must carry a total factored load moment of Mu = 400 ft-kips. Design the flexural reinforcement for this member,..

User Account

All Pages