What percent increase in shear force would be experience

Assignment Help Civil Engineering
Reference no: EM13549322

1.What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph? Kinematic viscosity of the air is 1.6x10^4 ft^2/s.

2.Determine the number of gallons of paint needed to paint the outside surface of the water-supply tank, which consists of a hemispherical bottom, cylindrical sides, and a conical top. Each gallon of paint can cover 250 ft^2

3. If 3% of the electric bulbs manufactured by a company are defective, Find the probability that in a sample of 100 bulbs,

(a) 0 bulbs will be defective (b) 1 bulbs will be defective

(c) 2 bulbs will be defective (d) 3 bulbs will be defective

(e) 4 bulbs will be defective (f) 5 bulbs will be defective

4.Find the probability that 200 tosses of a coin ill result in,

(a) between 80 and 120 heads inclusive (b) Less than 90 heads

(c) Less than 85 or more than 115 heads (d) exactly 100 heads

Reference no: EM13549322

Questions Cloud

You have been hired to analyze process piping for a food : You have been hired to analyze process piping for a food processing facility. They are using OD controlled sanitary piping to run water for a cooling jacket unit. Your job is to determine the maximum piping span.
Which measurement contributes to large amount of error : Which measurement contributes to large amount of error? how would you improve on these measurements if you repeated this lab exercise?
Determine the percentage of ball bearings with diameters : If the diameters of ball bearings are normally distributed with mean 0.6140 inches and standard deviation 0.0025 inches, determine the percentage of ball bearings with diameters,
What is the minimum grade a student must get : The mean grade on a final examination was 72, and the standard deviation was 9. The top 10% of the students are to receive A's. What is the minimum grade a student must get in order to receive an A ?
What percent increase in shear force would be experience : What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph? Kinematic viscosity of the air is 1.6x10^4 ft^2/s.
Flow occurs in a rectangular channel of 6 m width and has a : Flow occurs in a rectangular channel of 6 m width and has a specifi c energy of 3 m. Plot the q-curve. Determine from curve
How long can the turbines produce 380 of power from the : How long can the turbines produce 380.0 MW of power from the release of the mass of stored water calculated above? Assume the water sustains a friction loss of 39.5 m2/s2 on the way down to the turbine.
Calculate the uniform flow rate in an earth-lined : Calculate the uniform flow rate in an earth-lined (n = 0.020) trapezoidal canal having bottom width 3 m, sides sloping 1V : 2H, laid on a slope of 0.0001, and having depth of 1.8 m.
Determine the relationship between the discharge and the : A fluid of density rho flows steadily downward between the two vertical, infinite, parallel plates. The flow is fully developed and laminar. Make use of the Navier Stokes equation to.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Explain how to verify that the third central moment is zero

Write a computer program that generates a sequence of random variables from a normal distribution with mean 5 and standard deviation 2. a) Verify that sample mean and the sample variance converge to the respective population values.

  Does concentration exceed the 24-hr air quality standard

Suppose the average concentration of SO2 (SOsub2) is measured to be 400microgram/cu.m at 25degree celcius and 1 atm. Does this exceed the (24-hr) air quality standard of 0.14 ppm

  Explain indicated concentrations of total volatile solids

Influent sample collected from a wastewater treatment plant was analyzed for various solids concentrations. Results indicated concentrations of Total Volatile Solids (TVS)

  What is the maximum internal pressure in cylindrical vessel

The maximum hoop stress is (65000/2) psi and the maximum shear stress is 16000 psi. If the diameter of the tank is 7 inches,what is the minimum wall thickness.

  Find temperature at which air must leave heat exchanger

Gaseous oxygen (99% pure, molar basis) is to be produced at a rate of 350ft^3/hr in a Linde single column plant. The column operates at a pressure of 1 atm. Air leaves the compressor at a pressure of 10 atm.

  What is the mean momentum flow rate down the pipe

laminar flow of a real fluid down a cylindrical pipe of constant radius R. Poiseuille showed that the velocity profile was parabolic and given by u(r)=c(R^2-r^2), where r is the radial coordinate and c is a dimensional constant.

  What is the average crack spacing for that reinforcement

Compute the effective composite modulus of subgrade reaction (please consider the subbase, the presence of a relatively shallow rock foundation, and the potential loss of support)

  Determine normal depth and froude number a pvc pipe

A PVC pipe with a diameter of 30 inches will carry a flow of 20 cfs. the bottom slope is 0.005 and the roughness coefficient is 0.015. determine the normal depth, critical depth, velocity and the froude number.

  Determine how would distance be accomplished specifically

A sailboat capsizes a large distance from shore. What might be done to 1) right the boat and 2) prevent this from occurring again. How would this be accomplished specifically

  Determine the design speed of the curve

an equal-tangent sag vertical curve is designed with the PVC AT STation 109 + 00 and elevation 950 ft, the PVI at station 110 + 77 and elevation 947.34ft,and the low point at station 110 + 50 . Determine the design speed of the curve.

  Describe what is the definition of a friend function

Provide the function prototype for the following function if it is to be declared as a friend function of class Planet. Include the class declaration and the proper access attribute, but you are not required to add any additional class data or fun..

  Would it still be normally consolidated with the water

Estimate the value of the coefficient of at-rest earth pressure forthe deposit. If, when the water table was at the ground surface, the deposit was normallyconsolidated,would it still be normally consolidated with the water tablelowered? A reason mus..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd