What net torque must be applied to the wheel

Assignment Help Physics

Reference no: EM13713252

Formulate the answer of the following question

Question- A small grinding wheel has a moment of inertia of 4.0×10⁵kg.m².

Part 1- What net torque must be applied to the wheel for its angular acceleration to be 150rad/s²?

The tune-up specifications of a car call for the spark plugs to be tightened to a torque of 38N.m. You plan to tighten the plugs by pulling on the end of a 20-cm-long wrench. Because of the cramped space under the hood, you'll need to pull at an angle of 130^owith respect to the wrench shaft. With what force must you pull?

I need help to express the answer of the above question.

Reference no: EM13713252

Questions Cloud

What will be the composition of the vapor stream : A compressed liquid mixture of 42 mol percent n-hexane (1) and 58 mol percent ethane (2) is to be fed to a flash tank where the pressure is reduced and a liquid and vapor stream separated. The flashing operation will be carried out at 32 °C. The liqu..

How much work is done on the canister : The only force acting on a 4.2 kg canister that is moving in an xy plane has a magnitude of 5.3 N. How much work is done on the canister by the 5.3 N forces during this time.

Vapor power plant operates at steady state : A well-insulated tank in a vapor power plant operates at steady state. Water enters at inlet 1 at a rate of 125lb/s at 14.7lbf/in^2. Make up water to replenish steam losses from the plant enters at inlet 2 at a rate of 10 lb/s at 14.7 lbf/in^2 and 60..

Rate of heat transfer to the steam in the reheater : Air enters a compressor at 105 kPa and 300 K with a volumetric flow rate of 12 m3 /min and exits at 1200 kPa and 400 K. Heat transfer occurs at a rate of 2 kW from the compressor to its surroundings. Assuming ideal-gas behavior for air, steady flow, ..

What net torque must be applied to the wheel : A small grinding wheel has a moment of inertia of 4.0×105kg.m2. What net torque must be applied to the wheel for its angular acceleration to be 150rad/s2.

Steam enters the high-pressure turbine : In a reheat-cycle power plant, steam enters the high-pressure turbine at 5 MPa, 450°C, and expands to 0.5 MPa, after which it is reheated to 450°C. The steam is then expanded through the low-pressure turbine to 7.5 kPa. Liquid water leaves the conden..

Calculate the new pressure of the gas : A 3-Litre vessel contains gas at a pressure of 200 kPa. Five litres of gas at the same pressure is forced into the vessel. Calculate the new pressure of the gas. Use V1 = 8L, V2 = 3L

Air enters an automotive supercharger : Air enters an automotive supercharger at 100 kPa and 300 K and is compressed to 150 kPa. the efficiency is 70%. What is the required work input per kg of air?

Diamond shaped airfoil oriented to the oncoming stream : Consider a diamond shaped airfoil oriented to the oncoming stream. Approximate results since the inclination angles are small. All four faces are same length. Angle of attack is 10 deg. According to Newtonian hypersonic theory, Find the numerical val..

User Account

All Pages