What must be the rated horsepower of the motor

Assignment Help Civil Engineering
Reference no: EM13563648

An automobile has been designed to maintain a constant speed of 55 mph on a +5% grade. The weight of the vehicle when fully loaded is 6000 lbs. What is the total resistance in still air of this vehicle? What would be the resistance on a level road? What horsepower must be delivered to the wheels on the grade? If the efficiency is 80%, what must be the rated horsepower of the motor?

Use

R = 0.01T + 0.0001Tv + 0.0028CAv2

where

R = resistance (lb)

T = weight (lb)

v = velocity (mph)

C = air resistance parameter = 0.040

A = maximum cross section = 100 ft2

Discuss your results.

Reference no: EM13563648

Questions Cloud

Estimate how long has nora been jogging : Nora jogs several times a week and always keeps a journal ofhow much time she runs. How long has Nora been jogging when shereaches the bank
What is the magnitude of the velocity of the rain drop : When a train's velocity is 12.0m/s eastward, raindropsthat are falling vertically with respect to the earth make tracesthat are inclined 30degrees to the vertical on the windows of the train, What is the magnitude of the velocity of the raindrop
Determine tthe allowable soil bearing pressure with respect : Three soil borings were performed at the site of a structure and the SPT blow counts at each depth are shown below. (Do not make any corrections to the blow counts.
What is final velocity of originally stopped car : Car is traveling at constantspped, passes a car stopped, it accelerates at 7m/s2 , what is final velocity of originally stopped car
What must be the rated horsepower of the motor : An automobile has been designed to maintain a constant speed of 55 mph on a +5% grade. The weight of the vehicle when fully loaded is 6000 lbs. What is the total resistance in still air of this vehicle?
Determine what is the radius of the circular arc : A 50-kg pilot comes out of a vertical dive in a circular arcsuch that at the bottom of the arc her upward acceleration is 8.5g. what is the radius of the circular arc
Calculate the natural rate of groundwater discharge through : Given a potentiometric surface with a regional slope of 7m/km, calculate the natural rate of groundwater discharge through a confined aquifer with transmissivity (hydraulic conductivity times aquifer thickness) of 0.002 m2/s.
Describe mathematically and explain the principle of angular : Describe mathematically and explain the Principle of Angular Impulse and Momentum ? What is Conservation of Angular Momentum and how is it related?
What is the normal force exerted on the skate boarder : A skateboard track has the form of a circular arc with a 3.60m radius, What is the normal force exerted on the skate boarder at the bottom of the circular arc

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the concentration in ppm at the downstream reach

Five million gallons per day (mgd) of a conservative substance,with concentration of 10 mg/L is released into a stream having anupstream flow of 10.0 mgd and a substance concentration of 3 mg/L.Assume complete mixing.

  What is the manometer reading at b

A venturi meter is used to measure flow velocity. Given the manometer reading at A is 100 kPa, D = 10 cm, d = 5 cm, VA = 2 m/s, and specific weight of water is 9800 N/m3.

  Find e and deflections at points

Find e1, e2, e3 and deflections at those points

  A rod of steel is 20 m long at a temperature of 200c find

a rod of steel is 20 m long at a temperature of 200c. find the free expansion of the rod when the temperature is raised

  What will be the discharge at a depth of 50cm in the pipe

A concrete sewer pipe 1m in diameter is laid so it has a drop in elevation of 30cm per 300m of length. If sewage (assume the properties are the same as those of water) flows at a depth of 50cm in the pipe,

  Tangential component of the acceleration of the sled

Knowing that the coefficient of kinetic friction between a sled and the run is 0.10 and that the speed of the sled is 25 ft/s at B, determine the tangential component of the acceleration of the sled a) just before it reaches B, b) just after it pa..

  Find temperature at which air must leave heat exchanger

Gaseous oxygen (99% pure, molar basis) is to be produced at a rate of 350ft^3/hr in a Linde single column plant. The column operates at a pressure of 1 atm. Air leaves the compressor at a pressure of 10 atm.

  Given a saturated solution of calcium carbonate

Given a saturated solution of calcium carbonate ( atequilibrium ) how many moles of calcium ion will remain insolution after the addition of 3.16x10^-4 M of Na2co3 at 25C?(Assume PH is constant)

  Determine the minimum required depth of the beam

A simply supported beam (one end has a pin support and the other a roller support) is 10 ft long. The width of the beam is 3.5 in. The beam supports three concentrated loads

  Determine remaining load carrying capacity of cracked beam

a reinforced concrete beam with a section of 12 inches width and 24 inches depth is reinforced with 3no. 9 bars. fc'=5000psi and fy=60000psi. a 2 inch cover is used and the beam has a simply supported span lenght of 15ft.

  What would the weir coefficient be

If a source of groundwater gets contaminated with a DNAPL and another one gets contaminated with a LNAPL, which one will be harder to remediate and why ?

  What is turbine work output per kilogram of steam circulated

Steam enters the turbine of a single vapor power plant with a pressure of 10 MPa and a temperature of 580 C and expands adiabatically to 6 kPa. The isentropic turbine efficiency is 85%.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd