What must be the allowable elongation

Reference no: EM13555151

1.A cylindrical specimen of some alloy 50.26 mm2 in cross sectional area is stressed elastically in tension. A force of 1620 N produces a reduction in specimen diameter of 5 X 10-3 mm. Compute Poisson's ratio for this material if its modulus of elasticity is 140 GPa.

2.A cylindrical rod of brass alloy (E = 100 GPa,) having a yield strength of 345 MPa is to be subjected to a load of 7500 N. If the length and diameter of the rod are 338 mm and 7.55 mm respectively, what must be the allowable elongation?

Reference no: EM13555151

Questions Cloud

Is this soil a food foundation material : The results of a particle size analysis of a soil are given in the following table. No atterberg limit test were conducted.

Determine the liquid limit of this clay : The following results were obtained from a liquid limit test on a clay using the Casagrande cup device.

Determine lengths l1 and l2 so the two materials elongate : A solid cylinder of 50 mm diameter and 900 mm length is subjected to a tensile force of 120kN. One part f the cylinder L1 long is of steel, the other part

What is the percentage error in the bulk unit weight : What is the percentage error in the bulk unit weight if the soil is the percentage error in the bulk unit weight if the soil is 95% saturated but assumed to be 100% saturated?

What must be the allowable elongation : A cylindrical rod of brass alloy (E = 100 GPa,) having a yield strength of 345 MPa is to be subjected to a load of 7500 N. If the length and diameter of the rod are 338 mm and 7.55 mm respectively, what must be the allowable elongation?

What should be the concentration of pollutant : A lagoon with volume 1,200 m3 has been receiving a steady flow of a conservative waste at a rate of 100 m3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10 mg/L. assuming..

With what velocity will air enter the room under : Laboratories containing dangerous materials are often kept at a pressure slightly less than ambient pressure so that contaminants can be discharged through an exhaust system rather than leaked through cracks and around doors to other parts of the bui..

What concentration of ozone should be injected : Ozone is sometime used as a disinfectant for drinking water. Ozone is highly reactive it will react benign species found in water, as well as the pathogens it is intended to kill.

Determine the percentage increase in the discharge : As part of a drainage improvement project, a drainage ditch will be straightened and cleaned. As a result, the lenght of the ditch will decrease from 1800 ft to 1400 ft and the mannings roughness factor will be reduced

User Account

All Pages