What minimum weight of a body placed

Assignment Help Mechanical Engineering
Reference no: EM13993987

A sphere 1 m in diameter floats half submerged in a tank of oil( Sg = 0.80). a.) What is the upward force acting on the sphere? b.) What is the minimum weight of an anchor w/ a density of 20,000 N/m^3 that will be required to submerge the sphere completely? c.) What minimum weight of a body placed on the top of the sphere will be required to just submerge sphere completely?

Reference no: EM13993987

Questions Cloud

What is the activity at the end of the four year period : If there is 1 kg of Cm-242 initially, what is the activity of Cm-242 after 4 years? Assuming zero Pu initially, what is the Pu-238 activity at the end of the 4 year period?
What is a newtonian fluid : What is a Newtonian fluid?Explain in detail with an example
What prime brokerage is including four principal products : Describe what Prime Brokerage is, including four principal products in this area and the generic name of the financial institutions that are targeted for this business.
The two pipes are said to be equivalent : A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent
What minimum weight of a body placed : A sphere 1 m in diameter floats half submerged in a tank of oil( Sg = 0.80). a.) What is the upward force acting on the sphere? b.) What is the minimum weight of an anchor w/ a density of 20,000 N/m^3 that will be required to submerge the sphere comp..
The base of the tank and strikes : Water flows through a 2 cm opening in the side of a tank. If the opening is 8 m below the surface of the water,what volume of a water would escape from the tank per minute?If a stream of water escapes from another hole 2 m above the base of the tank ..
What is the self-help doctrine : What is the self-help doctrine? When is this used in criminal law
Which ones offer the subsidiary the most and least independ : Of the various methods by which a corporate subsidiary can be separated from the parent company in the public markets (IPO, carve-out, spin-off, split-off, and tracking stock), which ones offer the subsidiary the most and least independence?
Does the board sit in fresh water : A paddleboard is 12 ft long, 18 inches wide, 4.0 inches thick, and weighs 15 pounds. If the surfer weighs 170 pounds, how deep, in inches, does the board sit in fresh water?

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  An airplane wing modeled as a spring-mass system with

an airplane wing modeled as a spring-mass system with natural frequency 40 hz is driven harmonically by the rotation of

  Determine the exit velocity of the nitrogen

Nitrogen gas at 65kPa and 7C enters an adiabatic diffuser steadily with a velocity of 210 m/s and leaves at 119kPa and 22C. Determine  the exit velocity of the nitrogen. the ratio of the inlet to exit area

  If the scale graduations were printed on the tape under

a long steel tape measure 9.5 mm wide x 0.20 mm thick having an elastic modulus e 210 gpa is used to measure the width

  Calculate the pressure

Calculate the pressure, specific volume and temperature at the end ofeach process in the cycle and the thermodynamic efficiency of the cycle.

  Biological research facility

Stanford University is adding on to their biological research facility. The new facility will be 40 ft x 40 ft x 8 ft and can house 3000 laboratory mice. The indoor conditions must be maintained 75 F, 60% relative humidity when the outdoor conditions..

  Assuming the surroundings to be at 25degc determine a the

steam enters a turbine at 12 mpa 550degc and 60 ms and leaves at 20 kpa and 130 ms with a moisture content of 5

  A gas turbine for an automobile is designed with a

a gas turbine for an automobile is designed with a regenerator. air enters the compressor of this engine at 100 kpa and

  Find enthalpy and entropy at each phase also find all

thermodynamically analyze a hydrogen joule-thomson cycle ment to liquify hydrogen with isothermal compression occurring

  How many intake strokes have occurred in one cylinder

On your way home from class you spot your neighbour’s van on the side of the road. Later you run into him and he lets you know that the vehicle has finally quit after 160 000 miles Assume the van has been driven at an average speed of 45 miles-per-ho..

  What is the minimum coefficient of friction necessary

you have been asked to design a four-wheel drive vehicle capable of ascending a 24 degree ramp. what is the minimum

  Circumference of the tube

The fins are equally spaced around the circumference of the tube, each having a thickness of 2 mm and a length of 15 mm. What is the corresponding overall heat transfer coefficient Uc?

  Optimal amount of coffee distributed

Main Objective:  To determine the optimal amount of coffee distributed among the three destinations in order to reduce delivery cost.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd