What minimum power must be supplied to the generator

Assignment Help Physics
Reference no: EM13243872

The moving non-conducting belt of a Van de Graaff generator carries 10 µC of charge up to the metal sphere each second. The steady-state potential difference between the sphere and the grounded source of charge is 250 kV. What minimum power must be supplied to the generator (by the motor moving the belt) to sustain its operation?

Reference no: EM13243872

Questions Cloud

What is the potential difference dv between points : An equipotential line surrounds a charge distribution of known value (35 mC). Two points A and B are selected on this equipotential line separated by 3.0 cm. What is the potential difference DV between these points
Define what are the maximun number of electrons : What are the maximun number of electrons when n=4; n=5, ml=1; n=5, ms=+1/2; n=3, l=2; n=2, l=1. Please show all work.
Use the spss output to determine : Use the SPSS output to determine if there is sufficient evidence to conclude that Sally bakes a better pie than Pat (i.e., the average rating for Sally at her church is higher than the average rating for Pat at her church).
What would be the effect of a 2 percent increase in income : the price of elasticity of demand for tvs in canada is 1.2 and the income elasticity of demand for automobiles is 3. What would the effect of a 3 percent decline in tv prices on thequantity of tvs demanded.
What minimum power must be supplied to the generator : The moving non-conducting belt of a Van de Graaff generator carries 10 µC of charge up to the metal sphere each second, What minimum power must be supplied to the generator to sustain its operation
Explain the effectiveness of the salt bridge : Small air bubbles in the salt bridge may not be a problem. How can the presence of air bubbles in the salt bridge alter the effectiveness of this salt bridge
Explain why is it important to clean the surface of the zinc : Why is it important to clean the surface of the zinc and copper electrodes with 1 M HNO3 immeadiately before using them in this experiment.
Calculate marginal propensity to consume after the change : Calculate the marginal propensity to consume after the change in the rate of savings for the following scenerio: 20 years ago the average savings rate was 20 percent ofdisposable income
Determine how much mass m of ice should be added : The temperature of 2.10 kg of water is 34 °C. To cool the water, ice at 0 °C is added to it. The desired final temperature of the water is 11 °C, determine how much mass m of ice should be added.

Reviews

Write a Review

Physics Questions & Answers

  Determine the energy lost to friction throughout that time

A spool of thin wire (with inner radius r = 0.50 m, outer radius R = 0.65 m, and moment of inertia I_cm = 1.1323 kg*m2) pivots on a shaft.

  The centripetal and tangential accelerations are equal

The centripetal and tangential accelerations are equal

  What is the distance between your eye and the image

A 110 granite cube slides down a 45 degree frictionless ramp. At the bottom, just as it exits onto a horizontal table, it collides with a 235 steel cube at rest. How high above the table should the granite cube be released to give the steel cube a..

  What is the estimated cost to developed countries

A convex lense of focal length 18 cm is used as a magnifying glass. at what distance from a tiny insect must you hold this lense to get a magnification of 3.

  Explain the michelson-morley experiment

What speed would Michelson have computed for Earth's motion through the ether had the experiment seen a shift of one fringe

  How much energy is released

A capacitor is discharged when a wire is connected across its terminals, How much energy is released for a 1.00 uF capacitor with 10.0 V across its plates

  Compute the charge per length for the capacitor

A toy train is pushed forward and released at x_0 = 2m with a speed of 2m/s. It rolls at a steady speed for 2s, and then one wheel begins to stick. The train comes to a stop 6m from the point at which it was released. What is the magnitude of trai..

  Calculate the speed of each particle

An electron and a proton are each placed at rest in a uniform electric field of magnitude 564 N/C. Calculate the speed of each particle 44.4 ns after being released.

  What maximum distance does block move from initial position

Two balls of the same mass are accelerated by different net forces such that one ball gains a velocity twice that of the other ball in the process. Is the work done by the net force acting on the faster moving ball twice that done on the slower mo..

  Explain how far up the ladder can man climb

The coefficient of friction between the ladder and ground is 0.6 and the ladder makes an angle, theta with the ground equal to 50 degrees. Explain how far up the ladder can an 800N man climb before the ladder begins to slip?

  Find the upward force due to air resistance

A falling skydiver of mass 86.0 kg accelerates downward at 6.7 m/s2. What is the upward force due to air resistance

  How tall is the image formed by the diverging lens

In the figure below, the converging lens' focal length is 13 cm, d = 18 cm, and the diverging lens' focal length is -12.6 cm, How tall is the image formed by the diverging lens

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd