What logic function is most suitable for the operation

Assignment Help Electrical Engineering
Reference no: EM13246882

A light comes on in a storeroom when either (or both) of two doors is open.
1. What logic function is most suitable for this operation?
2. Draw a circuit to represent each function using a logic gate
3. Draw a circuit to represent each function using switches.

Reference no: EM13246882

Questions Cloud

Explain an aqueous solution via the reaction mno4 : The MnO4(-) is often used to analyze for the Fe(2+) content of an aqueous solution via the reaction MnO4(-) + Fe(2+) ---> Fe(3+) + Mn(2+) in acidic solution. What is the ratio of Fe(2+):MnO4(-) in the balanced equation
Determine the initial velocity of a silver bullet : what is the initial velocity of a silver bullet if it completely melts when striking a werewolf? the initial temperature of the bullet is 300
Conducted a study on the effects of stress : The researcher computed the number of migraines individuals reported during a six-month time frame as a function of the amount of stress they reported during that same time period. There were three stress levels: low, mild, and severe.
Find the speed of the airplane relative to the air : After flying for 15 min in a wind blowing 42 km/h at an angle of 32° south of east, What is the speed of the airplane relative to the air
What logic function is most suitable for the operation : A light comes on in a storeroom when either (or both) of two doors is open. 1. What logic function is most suitable for this operation 2. Draw a circuit to represent each function using a logic gate
Determine the total power radiated by the sun : The mean distance between the Earth and the Sun is 1.50×1011 m. The average intensity of solar radiation incident on the upper atmosphere of the Earth is 1390 W/m2, determine the total power radiated by the Sun
Define when electrons in a molecule are not found : WHen electrons in a molecule are not found between a pair of atoms but move throughout the molecule, this is called
What is goldbergs rationale for the study : What is Goldberg's rationale for the study? Was the study designed to contribute to theory? Do the results of the study contribute to theory? For both questions: If so, how? If not, why not?
What is the angular velocity of the sphere at the bottom : A solid sphere with a radius of 75 mm rolls (without slipping) down an inclined plane that is 5 m long. What is the angular velocity of the sphere at the bottom of the plane if it requires 10 seconds for it to reach the bottom

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the distribution of the number of customers

Determine the distribution of the number of customers waiting in the queue.

  Resize lighting system assuming a lighting level at bench

An office building of 20,000 ft2 would then take 40,000 watts of lighting at 2 watts /ft2. which amounted to 667 - 60 watt light bulbs or about the same two-bulb fluorescent fixtures. Resize the lighting system (W) assuming a lighting level.

  Saw on internet some equations to convert from frequency

Saw on internet some equations to convert from frequency in hertz to mph. Some equations need a gear ratio while others do not. I found the equation mph = circumference * RPM * 60.

  Describe what transpires when an interrupt occurs

What is an interrupt service routine What benefit does the ISR have over standard polling code Discuss challenges experienced in developing the dual interrupt software code.

  Which of the branches in sequence would be mis-predicted

Assume that we try to predict this sequence with a BHT using one-bit counters. The counters in the BHT are initialized to the N state. Which of the branches in this sequence would be mis-predicted?

  What is the op-amps open loop bandwidth

the upper critical frequency of anop-amps open loop response is 200Hz. If the midrange gain is 175,00, what is the ideal gain at 200Hz? what is th actual gain? what is the op-amps open loop bandwidth?

  Determine the decimal value of signed binary number

Determine the decimal value of each of the following SIGNED binary number displayed in the 2's complement form: a. 10011001 b. 01110100 c. 10111111

  Compare a lumped element model of a lossless transmission

Compare a lumped element model of a lossless transmission line (single L and C) with the distributed model. Use the following values for the transmission line in this comparative analysis.

  Need to use multisim and proteus

Need to use multisim and proteus and have build the circuit diagram on multisim and proteus, also have the program written, all u need to do its simulate it and take the necessary results.

  What is specific application or product involve z-transform

What is specific application or product that might involve the z-transform and how is it relevant in the application or design of the application or porduct

  What is the time function of the incident electric field

A 9 GHz parallel polarized wave with an amplitude of 20 V/m is obliquely incident from air (z 0). Theta_i equals a 60-degree angle of incidence.

  How to write a subroutine in assembler for the hcs12

In and Th are inputs and Out is the result. All parameters are 8-bit unsigned integers. A typical calling shows that the two inputs, In and Th, are passed on the stack and the return parameter Out, is returned in RegB.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd