What length of time in the model corresponds to one day

Assignment Help Civil Engineering

Reference no: EM13536836

1- A 1:2000 scale tidal model is operated to satisfy Froude’s law. A velocity of 0.02 ft/s is observed in the model. What is the velocity at the corresponding point in the prototype? What length of time in the model corresponds to one day in the prototype?

2- An overflow spillway 1,600 feet long is designed to pass 120,000 ft3/s of water. A 1:20 scale model of the cross section of the structure is built in the laboratory. It is assumed that the flow is two dimensional so only a 1-foot section (rather than the 80-feet section) is built. Calculate the required laboratory flow rate for the 1-ft section assuming that the viscosity and surface tension can be neglected. The pressure at a point in the model is observed to be -1.0 psi. What would be the pressure at this point in the prototype? What is the interpretation of this kind of pressure in the prototype?

Reference no: EM13536836

Questions Cloud

Determine the minimum required wire diameter assuming : A large steel tower is to be supported by a series of steel wires; it is estimated that the load on each wire will be 19,000N. Determine the minimum required wire diameter assuming a factor of safety 5 and that the yield strength of the steel is 900M..

Determine the entrance losses : A 40 cm diameter well has been constructed in a water-table aquifer. A pump capable of continuous discharge at 600 m3/day has been installed to test the well. Observation wells are located 10 meter and 50 meters from the pumped well. After pumping co..

What is the coefficient of static friction : A chair weighing 150 rests on a level floor that is not frictionless. A man pushes on the chair with a force = 43.0 that is directed at an angle of 34.0 with the horizontal. Assume that the chair is stationary but is on the verge of sliding.

When a net amount of work is done on a closed : When a net amount of work is done on a closed system undergoing an INTERNALLY REVERSIBLE process, a net heat transfer of energy from the system also occurs.

What length of time in the model corresponds to one day : A 1:2000 scale tidal model is operated to satisfy Froude’s law. A velocity of 0.02 ft/s is observed in the model. What is the velocity at the corresponding point in the prototype? What length of time in the model corresponds to one day in the prototy..

Determine the rotation of the gear at e : The two shafts are made of A-36 steel. Each has a diameter of 25 mm and they are connected using the gears fixed to their ends. Their other ends are attached to fixed supports at A and B

What is the probability of a water shortage in this city : During the next month, the amount of water available for a city is lognormally distributed with a mean of 1 million gallons and a c.o.v. of 40%, where as the total demand is expected to follow a lognormal distribution with a mean of 1.5 million gallo..

Explain how these effects were initiated : Is it possible (in this part of the world) for the sun to ever shine directly upon the OUTSIDE of a NORTH-facing wall of a home or other building? If so when?

Determine the magnitude and the point of application the : Determine the magnitude and the point of application the resultant of the four wind forces (distance right of AB, and distance below BC) when a=1.5ft and b=13ft.

User Account

All Pages