What is vertical stress increment due to the load at a point

Assignment Help Civil Engineering
Reference no: EM13316946

A concentrated load of 200 kips is applied to the ground surface. What is the vertical stress increment due to the load at a point 15 ft below the ground surface at a horizontal distance of 10 ft from the line of the concentrated load?

Reference no: EM13316946

Questions Cloud

What is the bounce back speed right after the impact : A crane drops a 1.0 kg steel ball onto a steel plate. The balls speed just before impact is 2.0m/s. what is the bounce back speed right after the impact
Determine vertical stress increment due to the strip load : Soil with a unit weight of 19.65 kN/m^3 is loaded on the ground surface by a strip load of 1.5 m wide. The strip load is 365 kN/m of wall length. Determine the vertical stress increment due to the strip load and the total pressure
Find the vertical stress increment due to the load at depth : A 12 ft x 12 ft square area carrying a uniform load of 5000 lb/ft^2 s applied to the ground surface. Find the vertical stress increment due to the load at a depth of 25 ft below the center of the loaded area.
What is the speed of the first marble : A 49g marble moving at 1.9m/s strikes a 24g marble at rest. What is the speed of the first marble immediately after the collision
What is vertical stress increment due to the load at a point : A concentrated load of 200 kips is applied to the ground surface. What is the vertical stress increment due to the load at a point 15 ft below the ground surface at a horizontal distance of 10 ft from the line of the concentrated load
What is the length of the pipe : Two adjacent resonant frequencies of an organ pipe are found to be 500 Hz and 600 Hz. What is the length of the pipe
What is max depth that can be safely reached for drilling : If the pipe is designed with a safety factor of two [i.e. the maximum stress in the field must be less than half the rated yield stress], what is the maximum depth that can be safely reached for drilling.
To what tension must the wire be tightened : A steel wire on a guitar has a length of 0.500 m and a mass of 3.50 x 10^-3 kg. To what tension must the wire be tightened
What is the probability that both rain and lightning occur : Let event Y be a rainstorm on a given day and event X be lightning on a given day. Let probability of these events be: P(X)=0.3 P(Y)=0.1 P(Y|X)=0.5 What is the probability that both rain and lightning occur on a given day

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is time-mean speed and space-mean speed for vehicle

assume you are an observer standing at a point on the track for a period of 30 minutes and are recording the instantaneous speed of each vehicle as it crosses your point. what is the time-mean speed and space-mean speed for these vehicles for this..

  What is the minimum bottom width to effect the depth

A trapezoidal channel is to be designed to carry a discharge of 250 cfs at a normal depth of 3.5 ft. The channel is running on a slope of 0.005 ft/ft and the side slopes can be no steeper than 2.5 H on 1 V.

  Determine the volume of irrigation water needed in ac-ft

A certain crop has a consumptive use requirement of 1.2 ac-ft of water per acre of crop land. The crop is planted on 780 acres of land. Precipitation falling during the growing season is 3.2 inches.

  Determine the maximum allowable length of the box

A square yellow-brass bar must not stretch more than 2.5 mm when it is subjected to a tensile load. Knowing that E = 1.5 GPa and that the allowable tensile strength is 150 MPa

  Set up the problem and constraints using algebraic symbols

Two factories are manufacturing and supplying a single type of good to four warehouses. The factories can produce a1, and a2 units of the good each month, and the warehouses need b1, b2, b3, and b4 units each month

  Estimate how long it will take before the daily maximum

Estimate the steady state PM10 concentration assuming a PM10 deposition velocity of 0.12 cm/s, prevailing wind velocity of 2.5 m/s, and a constant emission flux of PM10 0.82 mg/m2-s.

  Find the probability that more than 8 fail before 10 months

Suppose that under severe operation conditions, the lifetime, in months, of a transisitor is exponentially distributed with parameter d = 0.2. a. Find the probability that such a transistor lasts longer than 8 months.

  Estimate the volume of recharge during the rainy season

A volume of 1.5x106 m3 of water is then pumped out of the aquifer resulting in a decrease of the groundwater level to 208.8 m. Assuming that the water table in the aquifer responds similarly

  Determine approximately what the ratio of the density of air

Consider an air bubble rising from the bottom of a lake. Neglecting surface tension, determine approximately what the ratio of the density of the air in the bubble will be at a depth of 34ft to its density at a depth of 8 ft

  Esimating the capacity of the roadway

Given s=.30/(60-u), where s is the spacing (space headway) in miles, and u is the speed in miles per hour, derive the relationships u-k, u-q, and q-k. Also, estmate the capacity (qmax) of the roadway.

  Help with a site plan

Help with a site plan - Design on paper to add some other things in it.

  Determine probabilities of different events of flood wall

A temporary flood wall has been constructed to protect several homes in the floodplain. the wall was built to withstand any discharge up to the 20-year period after all the homes have been relocated.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd