What is this maximum power

Reference no: EM13251287

The potential difference between the terminals of a battery is 12V when measured directly using a voltmeter. When the battery is connected to a load of 240?, the reading of the voltmeter becomes 9.6V. What is the internal resistance of the battery? What load resistance should be used so the battery delivers the most power to it? What is this maximum power?

Reference no: EM13251287

Questions Cloud

Determine the resistivity of copper : A volltage drop of 0.00039 V is measured across a 1.2 m long piece of copper wire when 10 mA of current passes through it. What is the resistivity of copper

Design a 3-bit incrementer-decrementer : Design a 3-bit Incrementer/decrementer use btn_west as incrementer, i.e. when pressed, count increments by 1 use btn_east as decrementer, i.e. when pressed, count decrements by 1 use btn_south as reset, i.e. when pressed the count is resetted to 0.

Find maximum height does the golf ball achieve after impact : A golf club striking a golf ball imparts a force of2100N over a time of 5.06×10?3s at an angle of 35.0? above the horizontal. What maximum height does the golf ball achieve after impact

Multiple-baseline design differ from a reversal design : What is Goldbergs rationale for the study? Was the study designed to contribute to theory? Do the results of the study contribute to theory and how does a multiple-baseline design differ from a reversal design?

What is this maximum power : The potential difference between the terminals of a battery is 12V when measured directly using a voltmeter. What is this maximum power

What are assumptions used in low-level injection of carriers : The mobility of electrons in certain semiconductor is 1400 cm2/ (volt x sec). At room temperature (T=300K) calculate the diffusion length of electrons. What are the assumptions used in low-level injection of carriers

Determine which material will need more thickness : Semiconductor A is direct band gap and semiconductor B is indirect gap. For providing same short circuit current density of a solar cell, which material will need more thickness

Explain nitrogen fertilizer is produced industrially : Urea (NH2CONH2) an important nitrogen fertilizer is produced industrially by the reaction given that ?G initial = -13.6KJ, calculate ?G at 298K for the following sets of conditions

How to check if the bulb is bad and needs replacing : An incandescent light bulb can be modeled as a resistor with a value of a few ohms. Imagine an incandescent light bulb goes out in your house. Using your trusty multimeter, how would you check if the bulb is bad and needs replacing

User Account

All Pages