What is the volume of the water at the end of the process

Assignment Help Mechanical Engineering

Reference no: EM13711571

A piston-cylinder device containing .1 Kg of saturated liquid water, initially at 1 bar, is heated at constant pressure until the temperature is 140C. an electrical heater within the device is turned on and is allowed to pass a current for 5 min from a 120V source. if the amount of heat transfer to the water is 166KJ, what is:

The initial temp of the water?

The phase of the water at the end of the process?

What is the volume of the water at the end of the process?

What is the total boundary work produced during the process?

What is the current passing through the electric heater?

Reference no: EM13711571

Questions Cloud

What is the temperature of the exhaust gas : A 4 cylinder 1.6 liter SI engine has a compression ratio of 10, connecting rod length of 16.8cm, and a crank offset of 4.5 cm. The engine is operating at 3000 RPM and wide open throttle. The exhaust pressure is 100 kPa. The intake valve closes at 20 ..

Mixture temperature leaving the mixing chamber : In air-conditioning systems, streams of cold and warm air are mixed to get air with the right temperature. Consider a mixing chamber into which cold air enters at 8C and 100 kPa at a rate of 0.55 m^3 /s and warm air enters at 300C and 100 kPa. The ra..

Matlab code to calculate and plot the second explosion limit : Write a matlab code to calculate and plot the second explosion limit (2k1=k9[m] for the H2- air mixture with Phi=0.5 within temperature range of 500-1000k compare the line with the explosion limit in the textbook and see if they qualitatively agree. ..

Rooftop solar hot water heater with collector areas : A rooftop solar hot water heater with collector areas of 8 m2 and storage of 640 L is installed in Phoenix, Arizona on a house that uses 160 L/day of hot water at 60°C. 70% of the total energy required is supplied by solar energy (the solar fraction ..

What is the volume of the water at the end of the process : A piston-cylinder device containing .1 Kg of saturated liquid water, initially at 1 bar, is heated at constant pressure until the temperature is 140C. an electrical heater within the device is turned on and is allowed to pass a current for 5 min from..

Resolve together to determine bearing stress : If there are two forces acting perpendicular to each other at the same pin, do they resolve together to determine bearing stress?

Heat is transferred to the refrigerant such that pressure : A 4.40-ft^3 rigid tank contains saturated refrigerant-134a at 100 psia. Initially, 26 percent of the volume is occupied by liquid and the rest by vapor. A value at the top of the tank is now opened, and vapor is allowed to escape slowly from the tank..

Burning of the fuels and an atmospheric temperature : Two different fuels are being considered for a 1 MW (net output) heat engine which can operate between the highest temperature produced during the burning of the fuels and an atmospheric temperature of 300 K. Fuel A burns at 2,500 K, delivering 50 MJ..

Calculate the work done on the object by the force : A force of F= (-2i+8j-6k)N is applied to an object that is constrained to move in the direction u=0.5571i+0.4481j-0.6992k. If the object has a total displacement of 10 meters in the direction of u, calculate the work done on the object by the force.

User Account

All Pages